Hi, On Wednesday 05 June 2013 10:34 PM, Dan Murphy wrote: > Sricharan > > Thanks for sending this up in the series. > > On 06/05/2013 01:46 AM, Sricharan R wrote: >> From: Dan Murphy <[email protected]> >> >> Add support for blue LED 1 off of GPIO 153. >> Make the LED a heartbeat LED >> Configure the MUX for GPIO output. >> >> Cc: Dan Murphy <[email protected]> >> Signed-off-by: Dan Murphy <[email protected]> >> [Sricharan R <[email protected]>: Replaced constants with preprocessor >> macros] >> Signed-off-by: Sricharan R <[email protected]> >> --- >> arch/arm/boot/dts/omap5-uevm.dts | 17 +++++++++++++++++ >> 1 file changed, 17 insertions(+) >> >> diff --git a/arch/arm/boot/dts/omap5-uevm.dts >> b/arch/arm/boot/dts/omap5-uevm.dts >> index cf862df..a2aed5b 100644 >> --- a/arch/arm/boot/dts/omap5-uevm.dts >> +++ b/arch/arm/boot/dts/omap5-uevm.dts >> @@ -66,6 +66,16 @@ >> device = <&hsusb2_phy>; >> clock-frequency = <19200000>; /* 19.2 MHz */ >> }; >> + >> + leds { >> + compatible = "gpio-leds"; >> + led@1 { >> + label = "omap5:blue:usr1"; >> + gpios = <&gpio5 25 GPIO_ACTIVE_HIGH>; /* gpio5_153 D1 >> LED */ >> + linux,default-trigger = "heartbeat"; >> + default-state = "off"; >> + }; >> + }; >> }; >> >> &omap5_pmx_core { >> @@ -77,6 +87,7 @@ >> &mcbsp1_pins >> &mcbsp2_pins >> &usbhost_pins >> + &led_gpio_pins >> >; >> >> twl6040_pins: pinmux_twl6040_pins { >> @@ -175,6 +186,12 @@ >> 0x6e (PIN_OUTPUT | MUX_MODE6) /* gpio3_79 OUTPUT | MODE >> 6 ETH_NRESET */ >> >; >> }; >> + >> + led_gpio_pins: pinmux_led_gpio_pins { >> + pinctrl-single,pins = < >> + 0x196 (PIN_OUTPUT | MUX_MODE6) /* >> uart3_cts_rctx.gpio5_153 OUTPUT | MODE6 */ > Same comment from Florian. We can drop the OUTPUT | MODE6 in the comment. Ok thanks, Corrected in V2.
Regards, Sricharan -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
