fb1585bc13b (mtd: nand: omap2: clean-up BCHx_HW and BCHx_SW ECC
configurations in device_probe) introduced a warning when the new option
is disabled, i.e. with omap2plus_defconfig:
drivers/mtd/nand/omap2.c:1075:13: warning: 'omap3_enable_hwecc_bch' defined but
not used [-Wunused-function]
Fix this by rescoping the ifdef. Also remove a redudant #endif/#ifdef
pair.
Signed-off-by: Olof Johansson <o...@lixom.net>
---
drivers/mtd/nand/omap2.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/mtd/nand/omap2.c b/drivers/mtd/nand/omap2.c
index c4c7e0d..cbf8b28 100644
--- a/drivers/mtd/nand/omap2.c
+++ b/drivers/mtd/nand/omap2.c
@@ -1060,6 +1060,7 @@ static int omap_dev_ready(struct mtd_info *mtd)
}
}
+#ifdef CONFIG_MTD_NAND_OMAP_BCH
/**
* omap3_enable_hwecc_bch - Program OMAP3 GPMC to perform BCH ECC correction
* @mtd: MTD device structure
@@ -1141,7 +1142,6 @@ static void omap3_enable_hwecc_bch(struct mtd_info *mtd,
int mode)
writel(ECCCLEAR | ECC1, info->reg.gpmc_ecc_control);
}
-#ifdef CONFIG_MTD_NAND_ECC_BCH
/**
* omap3_calculate_ecc_bch4 - Generate 7 bytes of ECC bytes
* @mtd: MTD device structure
@@ -1959,8 +1959,7 @@ static int omap_nand_probe(struct platform_device *pdev)
omap_oobinfo.oobfree->offset = omap_oobinfo.eccpos[0] +
omap_oobinfo.eccbytes;
goto custom_ecc_layout;
-#endif
-#ifdef CONFIG_MTD_NAND_ECC_BCH
+
case OMAP_ECC_BCH8_CODE_HW_DETECTION_SW:
pr_info("using OMAP_ECC_BCH8_CODE_HW_DETECTION_SW ECC\n");
info->nand.ecc.mode = NAND_ECC_HW;
--
1.7.10.4
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
