Jeff, I did notice that and I'm using your tool now, but I wanted to use megacli to get logs from the controller the same logs that I get in omsa or using ipmitool -I open sel list - list log.
Good info below though. Thanks, Paul -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Jefferson Ogata Sent: Tuesday, April 13, 2010 2:19 PM To: [email protected] Subject: Re: debian monitoring On 2010-04-13 16:56, P.A wrote: > Prasana, thanks for the info, I actually had downloaded this but it > does not come with MegaCLI which is shown on the example page you have > below. I don't think megactl and megacli are the same, someone correct > me if im wrong. MegaCLI and megactl are definitely different. MegaCLI is the official configuration and inspection tool from LSI. megactl/megasasctl is an alternate program I authored that does some things MegaCLI does not do; in particular it uses SCSI passthrough to get info directly from the disks in a RAID so you can check error conditions at the drive controller level rather than the RAID controller level. It can also start disk self-tests and check their results. _______________________________________________ Linux-PowerEdge mailing list [email protected] https://lists.us.dell.com/mailman/listinfo/linux-poweredge Please read the FAQ at http://lists.us.dell.com/faq _______________________________________________ Linux-PowerEdge mailing list [email protected] https://lists.us.dell.com/mailman/listinfo/linux-poweredge Please read the FAQ at http://lists.us.dell.com/faq
