Hello...
Originally, I have redhat 5.0/kernel 2.0.32 on my linux box.
I went downloading kernel 2.0.34 and 2.0.35, did installed them in their
respective directories. That gives me following directories in /usr/src:
-/usr/src/linux
-/usr/src/linux-2.0.32
-/usr/src/linux-2.0.34
-/usr/src/linux-2.0.32
..What I did is to run make config( I did enable PPP support and all
others IP/networking suuport options )/make dep/make clean/make_modules,
make modules_install in each directory and copied their zImage in
/boot:
- cp /usr/src/li/usr/src/linux-2.0.32/arch/i386/boot/zImage
/boot/vmlinuz-2.0.32
-cp /usr/src/li/usr/src/linux-2.0.34/arch/i386/boot/zImage
/boot/vmlinuz-2.0.34
-cp /usr/src/li/usr/src/linux-2.0.35/arch/i386/boot/zImage
/boot/vmlinuz-2.0.35
Of course I also did:
In /boot: ln -sf vmlinuz-2.0.32 vmlinuz
ln -sf vmlinuz-2.0.34 vmlinuz
ln -sf vmlinuz-2.0.35 vmlinuz
Finally, in /etc/lilo.conf , there are several stanzas of my several
kernels.
I) What I could understand is that whatever kernel I m bootin, there is
a "trusted" kernel (if I can all it that way) and it s the original one
that was installed on my system (kernel 2.0.32)
right???
II) Whatever kernel I m bootin, the config files stay the same...but
this cause a problem:
for ie..on kernel 2.0.32 PPP was loaded as module. . On kernel 2.0.34 I
specifically recompile PPP in, but there s no appearent difference
between both. I still have to type commands like pppd -detach /dev/modem
..or /etc/ppp-on to connect to the net..
PPP, with or without kernel support...I do not see the difference!!
III) Is the way I ve configured my system right (with those 3 kernels)??
To make sure I m bootin the kernel of my choice, I copied the zImage of
each kernel on a floppy. So I just boot with the right floppy
Thanks
-
To unsubscribe from this list: send the line "unsubscribe linux-ppp" in
the body of a message to [EMAIL PROTECTED]
