Lo,
Situation: /dev/md0, type raid1, containing 2 active devices (/dev/hda1
and /dev/hdc1) and 2 spare devices (/dev/hde1 and /dev/hdg1).
Those two spare 'partitions' are the only partitions on those disks and
therefore I'd like to spin down those disks using hdparm for obvious
reasons (noise, heat). Specifically, 'hdparm -S <value> <device>' sets
the standby (spindown) timeout for a drive; the value is used by the
drive to determine how long to wait (with no disk activity) before
turning off the spindle motor to save power.
However, it turns out that md actually sort-of prevents those spare
disks to spindown. I can get them off for about 3 to 4 seconds, after
which they immediately spin up again. Removing the spare devices from
/dev/md0 (mdadm /dev/md0 --remove /dev/hd[eg]1) actually solves this,
but I have no intention actually removing those devices.
How can I make sure that I'm actually able to spin down those two spare
drives?
Thanks,
Marc.
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
