At 12:57 PM 9/17/1999 +0200, you wrote:
>Hello,
>
>we are trying to set up RAID1 as described in the Software-RAID-howto.
>
>md-support is compiled into the kernel (not as module) and RAID1 too.
>Raid0 ist not compiled in, because the Kernel appears to support Raid0
>for swap by default (correct me, when I'm wrong). Swap is setup as RAID0
>and seems to work fine.
>
>[RAID1]
>There are two partition equally sized on two different HDs:
>sdb6 and sdc6 both with no filesystem on them.
I have found that you need to re-partition the disks so you only have
partition 1 and 3...
3 is whole disk, 1 is type FD and starts at cyl 1, not 0
Raidtools doesn't like any other partitions.
===========================================================
David Cooley N5XMT Internet: [EMAIL PROTECTED]
Packet: N5XMT@KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
We are Borg... Prepare to be assimilated!
===========================================================
