Hello, I'm using the latest version of mkraid and tried to create a RAID1 device from hda1 and hdc1 (trying to set up a RAID1 boot device with the recently mentioned LILO disk geometry config options). Both partitions where set to type FD and the raidtab entry is fine, too. Alas when trying to do the actual "mkraid /dev/md5" it complained that /dev/hda1 was mounted, which it of course wasn't. After trying to force the issue and some scratching of my head I unmounted the partitions hda10 and hda11 (as well as hdc10 ;) and tried again. This time no complaints besides the fact that mkraid found an ext2fs filesystem on these partitions, that was to be expected and easily forced over. So it seems that mkraid should consider more than the first four characters of the actual partition name to distinguish partitions. Dewa, <CB> -- // <CB> aka Christian Balzer, Tannenstr. 23c, D-64342 Seeheim, Germany \X/ [EMAIL PROTECTED] | Voice: +49 6257 83036, Fax/Data: +49 6257 83037 SWB - The Software Brewery - | http://www.swb.de/ | Anime no Otaku
