The firmware of R-Car USB 3.0 host controller will control the reset.
So, if the xhci driver doesn't do firmware downloading (e.g. kernel
configuration is CONFIG_USB_XHCI_PLATFORM=y and CONFIG_USB_XHCI_RCAR
is not set), the reset of USB 3.0 host controller doesn't work
correctly. Then, the host controller will cause long wait in
xhci_reset() because the CMD_RESET bit of op_regs->command is not
cleared for 10 seconds.
So, this patch modifies the Kconfig to enable both CONFIG_USB_XHCI_PLATFORM
and CONFIG_USB_XHCI_RCAR.
Fixes: 4ac8918f3a7 (usb: host: xhci-plat: add support for the R-Car H2 and M2
xHCI controllers)
Cc: <sta...@vger.kernel.org> # v3.17+
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda...@renesas.com>
---
Changes from v2:
- Modify the Kconfig instead of xhci-rcar.h
http://www.spinics.net/lists/linux-usb/msg139681.html
http://www.spinics.net/lists/linux-usb/msg139722.html
Changes from v1:
- Revise the commit log.
http://www.spinics.net/lists/stable/msg130007.html
drivers/usb/host/Kconfig | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig
index 3050b18..e9d4dde 100644
--- a/drivers/usb/host/Kconfig
+++ b/drivers/usb/host/Kconfig
@@ -35,6 +35,7 @@ config USB_XHCI_PCI
config USB_XHCI_PLATFORM
tristate "Generic xHCI driver for a platform device"
+ select USB_XHCI_RCAR if ARCH_RENESAS
---help---
Adds an xHCI host driver for a generic platform device, which
provides a memory space and an irq.
@@ -63,7 +64,7 @@ config USB_XHCI_MVEBU
config USB_XHCI_RCAR
tristate "xHCI support for Renesas R-Car SoCs"
- select USB_XHCI_PLATFORM
+ depends on USB_XHCI_PLATFORM
depends on ARCH_RENESAS || COMPILE_TEST
---help---
Say 'Y' to enable the support for the xHCI host controller
--
1.9.1
