Dear Dong, On Thursday 19 Jan 2017 18:14:45 DongCV wrote: > Dear Mr Laurent > > I apologize for the misunderstanding.
No worries, I should have been more precise. > I've retested the HDMI output on Lager(H2) with v4.10-rc2. > > The results: > > Enabled CMA: > > The HDMI cable unplugged: Could not recognize the display. > The HDMI cable plugged: Recognized the display-> test fail. > > The VGA cable unplugged: Recognized the display-> test ok. > The VGA cable plugged: Recognized the display-> test ok. > > > Disabled CMA: The same to the case of enabled CMA. > > I attach the test procedures and test tool, test result. > Please have a look at it. I've followed the same test procedure: - Check out kernel v4.10-rc2 - Compile the kernel with the CONFIG_CMA_ENABLE.txt you have provided - Disconnect the VGA and HDMI cables - Turn the power on to the Lager board, let it boot - Plug the HDMI cable - Run 'bmap /dev/fb0 hdmi.bmp' with the hdmi.bmp file you have provided The output on the display is fine, identical to your 'VGA_Image.jpg' picture. At this point I believe the key difference between our setups is the HDMI monitor. Could you please send me the output of modetest -M rcar-du with the HDMI cable plugged ? -- Regards, Laurent Pinchart
