The EthernetAVB should not depend on the bootloader to setup correct
drive-strength values. Values for drive-strength where found by
examining the registers after the bootloader has configured the
registers and successfully used the EthernetAVB.
Based on:
* commit 7d73a4da2681 ("arm64: dts: r8a7795: salvator-x: Set drive-strength
for ravb pins")
* commit 4903987033be ("arm64: dts: r8a7796: salvator-x: Set drive-strength
for ravb pins")
Cc: Geert Uytterhoeven <[email protected]>
Cc: Niklas Söderlund <[email protected]>
Signed-off-by: Simon Horman <[email protected]>
---
* Compile tested only due to lack of hardware access
---
arch/arm64/boot/dts/renesas/ulcb.dtsi | 18 ++++++++++++++++--
1 file changed, 16 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/renesas/ulcb.dtsi
b/arch/arm64/boot/dts/renesas/ulcb.dtsi
index 7669b282bde2..a38d68c4d9a6 100644
--- a/arch/arm64/boot/dts/renesas/ulcb.dtsi
+++ b/arch/arm64/boot/dts/renesas/ulcb.dtsi
@@ -199,8 +199,22 @@
pinctrl-names = "default";
avb_pins: avb {
- groups = "avb_mdc";
- function = "avb";
+ mux {
+ groups = "avb_link", "avb_phy_int", "avb_mdc",
+ "avb_mii";
+ function = "avb";
+ };
+
+ pins_mdc {
+ groups = "avb_mdc";
+ drive-strength = <24>;
+ };
+
+ pins_mii_tx {
+ pins = "PIN_AVB_TX_CTL", "PIN_AVB_TXC", "PIN_AVB_TD0",
+ "PIN_AVB_TD1", "PIN_AVB_TD2", "PIN_AVB_TD3";
+ drive-strength = <12>;
+ };
};
i2c2_pins: i2c2 {
--
2.1.4
