Hi Geert,
Thanks for the patches, sorry I can't test these either... It's been quite a few
years since I had an sh7264 or sh7269 board!
Thanks
Phil
-----Original Message-----
On: 09 May 2017 16:44, Laurent Pinchart wrote:
Subject: Re: [PATCH/RFC 0/4] sh: sh7722/sh7757i/sh7264/sh7269: Fix pinctrl
registration
Hi Geert,
Thank you for the patches.
On Tuesday 09 May 2017 16:11:53 Geert Uytterhoeven wrote:
> Hi all,
>
> Magnus reported that on sh7722/Migo-R, pinctrl registration fails with:
>
> sh-pfc pfc-sh7722: pin 0 already registered
> sh-pfc pfc-sh7722: error during pin registration
> sh-pfc pfc-sh7722: could not register: -22
> sh-pfc: probe of pfc-sh7722 failed with error -22
>
> pinmux_pins[] is initialized through PINMUX_GPIO(), using designated
> array initializers, where the GPIO_* enums serve as indices.
> Apparently GPIO_PTQ7 was defined in the enum, but never used.
> If enum values are defined, but never used, pinmux_pins[] contains
> (zero-filled) holes. Hence such entries are treated as pin zero,
> which was registered before, and initialization fails.
>
> I can't see how this ever worked, as at the time of commit
> f5e25ae52feff2dc
> ("sh-pfc: Add sh7722 pinmux support"), pinmux_gpios[] in
> drivers/pinctrl/sh-pfc/pfc-sh7722.c already had the hole, and
> drivers/pinctrl/core.c already had the check.
>
> Some scripting revealed a few more broken drivers:
> - sh7757 has four holes, due to nonexistent GPIO_PT[JLNQ]7_RESV.
> - sh7264 and sh7269 define GPIO_PH[0-7], but don't use it with
> PINMUX_GPIO().
>
> Patch 1 fixes the issue on sh7722, and was tested.
> Patches 3-4 should fix the issue on the other 3 SoCs, but was untested
> due to lack of hardware.
This all looks good to me, even if I can't test or verify patches 2/4 to 4/4 as
I don't have access to the hardware or datasheet either. Given that they're
untested I wouldn't fake the error message in the commit log though, but just
refer to the problem noticed on sh7722.
Apart from that, for the whole series,
Reviewed-by: Laurent Pinchart <[email protected]>
> Thanks for your comments!
>
> Geert Uytterhoeven (4):
> sh: sh7722: Remove nonexistent GPIO_PTQ7 to fix pinctrl registration
> [RFC] sh: sh7757: Remove nonexistent GPIO_PT[JLNQ]7_RESV to fix
> pinctrl registration
> sh: sh7264: Remove nonexistent GPIO_PH[0-7] to fix pinctrl
> registration
> [RFC] sh: sh7269: Remove nonexistent GPIO_PH[0-7] to fix pinctrl
> registration
>
> arch/sh/include/cpu-sh2a/cpu/sh7264.h | 4 +---
> arch/sh/include/cpu-sh2a/cpu/sh7269.h | 4 +---
> arch/sh/include/cpu-sh4/cpu/sh7722.h | 2 +-
> arch/sh/include/cpu-sh4/cpu/sh7757.h | 8 ++++----
> 4 files changed, 7 insertions(+), 11 deletions(-)
--
Regards,
Laurent Pinchart
