Hi, This series reworks the R-Car VIN driver to only run using its continues capture mode. This improves performance a lot when userspace struggles to keep up and queue buffers as fast as the VIN driver consumes them. The solution to always be able to run in continues is to introduce a scratch buffer inside the VIN driver which it can pad the hardware capture buffer ring with if it have no buffer from userspace. Using this scratch buffer allows the driver to not need to stop capturing when it run out of buffers and then restart it once it have more buffers.
Patch 1/3 removes a duplicated check in the VIN interrupt handler. Patch 2/3 adds the allocation of the scratch buffer. And finally 3/3 drops the single capture mode in favor of always running in continues capture mode and the scratch buffer. The series is based on top of the latest media-tree master branch and can be fetched from. git://git.ragnatech.se/linux v4l2/next/vin/mode-v1 It is tested on R-Car Koelsch Gen2 board using the onboard HDMI and CVBS inputs. The test application v4l2-compliance pass for both inputs without issues or warnings. A slight adaption of these patches to the pending VIN Gen3 patches have been tested with great improvement in capture speed for buffer strained situations and no regressions in the vin-tests suite. Niklas Söderlund (3): rcar-vin: remove duplicated check of state in irq handler rcar-vin: allocate a scratch buffer at stream start rcar-vin: use scratch buffer and always run in continuous mode drivers/media/platform/rcar-vin/rcar-dma.c | 212 ++++++++++------------------- drivers/media/platform/rcar-vin/rcar-vin.h | 10 +- 2 files changed, 75 insertions(+), 147 deletions(-) -- 2.16.2
