Document 'data-active' property in R-Car VIN device tree bindings.
Signed-off-by: Jacopo Mondi <[email protected]>
v1 -> v2:
- HSYNC is used in place of data enable signal only when running with
explicit synchronizations.
- The property is no more mandatory when running with embedded
synchronizations, and default is selected.
---
Documentation/devicetree/bindings/media/rcar_vin.txt | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/Documentation/devicetree/bindings/media/rcar_vin.txt
b/Documentation/devicetree/bindings/media/rcar_vin.txt
index dab3118..2c144b4 100644
--- a/Documentation/devicetree/bindings/media/rcar_vin.txt
+++ b/Documentation/devicetree/bindings/media/rcar_vin.txt
@@ -64,6 +64,12 @@ from local SoC CSI-2 receivers (port1) depending on SoC.
If both HSYNC and VSYNC polarities are not specified, embedded
synchronization is selected.
+ - data-active: data enable signal line polarity (CLKENB pin).
+ 0/1 for LOW/HIGH respectively. If not specified and running with
+ embedded synchronization, the default is active high. If not
+ specified and running with explicit synchronization, HSYNC is used
+ as data enable signal.
+
- port 1 - sub-nodes describing one or more endpoints connected to
the VIN from local SoC CSI-2 receivers. The endpoint numbers must
use the following schema.
--
2.7.4
