Hi Marek,
On Fri, May 3, 2019 at 5:18 PM Marek Vasut <[email protected]> wrote:
> On 5/3/19 2:36 PM, Geert Uytterhoeven wrote:
> >> &rwdt {
> >> @@ -309,6 +314,8 @@
> >> };
> >>
> >> &iic3 {
> >> + pinctrl-names = "default";
> >> + pinctrl-0 = <&pmic_irq_pins>;
> >
> > Given Blanche has a single device connected to irq2, I think it makes
> > sense to move the pinctrl properties to the pmic node below.
>
> It makes blanche somehow inconsistent with the other boards, but if you
> insist ... ?
Typically the pinctrl properties are part of the device node that uses them.
For the other boards, that's not possible, as they are shared by all PMIC
nodes. Hence the other boards are the exceptions, actually ;-)
Note that for multi-PMIC boards, adding the pinctrl properties to a single
PMIC node won't work, as that would break:
1. The case where the driver for that PMIC is not compiled in,
2. The R-Car Gen2 regulator quirk.
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- [email protected]
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
