Mark Brown wrote: > > Use the new irqdomain support in the WM8994 driver to dynamically allocate > the interrupt range for the WM8994 rather than doing it explicitly. This > is more idiomatic for modern interrupt usage. > > Signed-off-by: Mark Brown <[email protected]> > --- > arch/arm/mach-s3c64xx/include/mach/crag6410.h | 1 - > arch/arm/mach-s3c64xx/mach-crag6410-module.c | 1 - > 2 files changed, 2 deletions(-) > > diff --git a/arch/arm/mach-s3c64xx/include/mach/crag6410.h > b/arch/arm/mach-s3c64xx/include/mach/crag6410.h > index 4cb2f951..ec97c15 100644 > --- a/arch/arm/mach-s3c64xx/include/mach/crag6410.h > +++ b/arch/arm/mach-s3c64xx/include/mach/crag6410.h > @@ -15,7 +15,6 @@ > > #define BANFF_PMIC_IRQ_BASE IRQ_BOARD_START > #define GLENFARCLAS_PMIC_IRQ_BASE (IRQ_BOARD_START + 64) > -#define CODEC_IRQ_BASE (IRQ_BOARD_START + 128) > > #define PCA935X_GPIO_BASE GPIO_BOARD_START > #define CODEC_GPIO_BASE (GPIO_BOARD_START + 8) > diff --git a/arch/arm/mach-s3c64xx/mach-crag6410-module.c b/arch/arm/mach- > s3c64xx/mach-crag6410-module.c > index 4979372..4a83b4e 100644 > --- a/arch/arm/mach-s3c64xx/mach-crag6410-module.c > +++ b/arch/arm/mach-s3c64xx/mach-crag6410-module.c > @@ -168,7 +168,6 @@ static struct wm8994_pdata wm8994_pdata = { > .gpio_defaults = { > 0x3, /* IRQ out, active high, CMOS */ > }, > - .irq_base = CODEC_IRQ_BASE, > .ldo = { > { .init_data = &wm8994_ldo1, }, > { .init_data = &wm8994_ldo2, }, > -- > 1.7.10
Yeah, I agree with your comments. Will apply. Thanks. Best regards, Kgene. -- Kukjin Kim <[email protected]>, Senior Engineer, SW Solution Development Team, Samsung Electronics Co., Ltd. -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
