The set_level callback in the controller data, which is used to configure
the slave select line, cannot be supported when migrating the driver to
device tree based discovery. Since all the platforms currently use gpio
as the slave select line, this callback can be removed from the
controller data and replaced with call to gpio_set_value in the driver.
Signed-off-by: Thomas Abraham <thomas.abra...@linaro.org>
Acked-by: Jaswinder Singh <jaswinder.si...@linaro.org>
Acked-by: Grant Likely <grant.lik...@secretlab.ca>
---
arch/arm/plat-samsung/include/plat/s3c64xx-spi.h | 2 --
drivers/spi/spi-s3c64xx.c | 11 ++++++-----
2 files changed, 6 insertions(+), 7 deletions(-)
diff --git a/arch/arm/plat-samsung/include/plat/s3c64xx-spi.h
b/arch/arm/plat-samsung/include/plat/s3c64xx-spi.h
index c818a7c..ceba18d 100644
--- a/arch/arm/plat-samsung/include/plat/s3c64xx-spi.h
+++ b/arch/arm/plat-samsung/include/plat/s3c64xx-spi.h
@@ -18,7 +18,6 @@ struct platform_device;
* @fb_delay: Slave specific feedback delay.
* Refer to FB_CLK_SEL register definition in SPI chapter.
* @line: Custom 'identity' of the CS line.
- * @set_level: CS line control.
*
* This is per SPI-Slave Chipselect information.
* Allocate and initialize one in machine init code and make the
@@ -27,7 +26,6 @@ struct platform_device;
struct s3c64xx_spi_csinfo {
u8 fb_delay;
unsigned line;
- void (*set_level)(unsigned line_id, int lvl);
};
/**
diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
index 0a9e43e..068600d 100644
--- a/drivers/spi/spi-s3c64xx.c
+++ b/drivers/spi/spi-s3c64xx.c
@@ -27,6 +27,7 @@
#include <linux/platform_device.h>
#include <linux/pm_runtime.h>
#include <linux/spi/spi.h>
+#include <linux/gpio.h>
#include <mach/dma.h>
#include <plat/s3c64xx-spi.h>
@@ -411,14 +412,14 @@ static inline void enable_cs(struct
s3c64xx_spi_driver_data *sdd,
if (sdd->tgl_spi != spi) { /* if last mssg on diff device */
/* Deselect the last toggled device */
cs = sdd->tgl_spi->controller_data;
- cs->set_level(cs->line,
- spi->mode & SPI_CS_HIGH ? 0 : 1);
+ gpio_set_value(cs->line,
+ spi->mode & SPI_CS_HIGH ? 0 : 1);
}
sdd->tgl_spi = NULL;
}
cs = spi->controller_data;
- cs->set_level(cs->line, spi->mode & SPI_CS_HIGH ? 1 : 0);
+ gpio_set_value(cs->line, spi->mode & SPI_CS_HIGH ? 1 : 0);
}
static int wait_for_xfer(struct s3c64xx_spi_driver_data *sdd,
@@ -504,7 +505,7 @@ static inline void disable_cs(struct
s3c64xx_spi_driver_data *sdd,
if (sdd->tgl_spi == spi)
sdd->tgl_spi = NULL;
- cs->set_level(cs->line, spi->mode & SPI_CS_HIGH ? 0 : 1);
+ gpio_set_value(cs->line, spi->mode & SPI_CS_HIGH ? 0 : 1);
}
static void s3c64xx_spi_config(struct s3c64xx_spi_driver_data *sdd)
@@ -833,7 +834,7 @@ static int s3c64xx_spi_setup(struct spi_device *spi)
unsigned long flags;
int err = 0;
- if (cs == NULL || cs->set_level == NULL) {
+ if (cs == NULL) {
dev_err(&spi->dev, "No CS for SPI(%d)\n", spi->chip_select);
return -ENODEV;
}
--
1.6.6.rc2
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
