James Bottomley wrote: > There's a slight problem in the way you've done the transport > parameters; reading from the variables actually produces the current > settings, not the ones you just set (and there's usually a lag because > devices don't renegotiate until the next command goes over the bus). If > you set the bit immediately, you get into the situation where the > transport parameters report something as being set even if the drive > cannot support it. > Well, as usual you're correct. I wasn't quite sure as to _when_ the transport class parameter will be set, as they appearently haven't been set correctly (this was whilst chasing down the ST/DT setting issue). But yours if of course the correct way of doing things.
> I patched the driver to do it this way and also corrected a panic in the > proc routines. > THX. Didn't even know there was a proc panic :-). Cheers, Hannes -- Dr. Hannes Reinecke [EMAIL PROTECTED] SuSE Linux Products GmbH S390 & zSeries Maxfeldstraße 5 +49 911 74053 688 90409 Nürnberg http://www.suse.de - To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html
