Hi,
Provisioning mode is not being set to "unmap" even though it seems
that device firmware provides all the required information to SD.
1. The TPE bit is set in the Read Capacity 16 response,
$ sudo sg_readcap --16 -H /dev/sg1
00 00 00 00 00 00 ff ff ff 00 00 10 00 00 01 80 00
10 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
so sdkp->lbpme will be set to 1 and sd_config_discard(sdkp,
SD_LBP_WS16); will be called which maps 'provisioning mode' to Write
Same 16.
2. Device supports SPC 3
First 3 bytes of Inquiry
$ sudo sg_inq -H /dev/sg1
standard INQUIRY:
00 00 00 06
So extended inquiry on the firmware will be done.
3. The device does not support VPD 0xb2.
$ sudo sg_vpd -p 0xb2 /dev/sg1
VPD page=0xb2
fetching VPD page failed
4. The device supports VPD - 0xb0
$ sudo sg_vpd -p 0xb0 /dev/sg1
Block limits VPD page (SBC):
$ sudo sg_vpd -p 0xb0 /dev/sg4
Block limits VPD page (SBC):
00 00 b0 00 3c 00 00 02 00 ff ff 00 00 02 00 00 00 ...<............
10 00 00 00 00 ff ff ff ff ff 00 00 00 00 20 00 00 ............. ..
20 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
30 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
Block limits VPD page (SBC):
Write same no zero (WSNZ): 0
Maximum compare and write length: 0 blocks
Optimal transfer length granularity: 512 blocks
Maximum transfer length: 4294901760 blocks
Optimal transfer length: 33554432 blocks
Maximum prefetch, xdread, xdwrite transfer length: 0 blocks
Maximum unmap LBA count: 4294967295
Maximum unmap block descriptor count: 4278190080
Optimal unmap granularity: 2097152
Unmap granularity alignment valid: 0
Unmap granularity alignment: 0
Maximum write same length: 0x0 blocks
So, sdkp->max_unmap_blocks = lba_count;
So the following piece of code should set provisioning_mode to UNMAP
if (!sdkp->lbpvpd) { /* LBP VPD page not provided */
if (sdkp->max_unmap_blocks)
sd_config_discard(sdkp, SD_LBP_UNMAP);
else
sd_config_discard(sdkp, SD_LBP_WS16);
}
But when I check the "/sys.../provisioning_mode" it is set to Write Same 16.
What am I missing here. What else SD is looking for.
-John
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
