Hardware timing requirements is updated in order to comply with firmware requirement.
Signed-off-by: Sreekanth Reddy <[email protected]> --- drivers/scsi/mpt3sas/mpt3sas_base.c | 20 +++++++++++++------- 1 files changed, 13 insertions(+), 7 deletions(-) diff --git a/drivers/scsi/mpt3sas/mpt3sas_base.c b/drivers/scsi/mpt3sas/mpt3sas_base.c index 673a1b5..5dc280c 100644 --- a/drivers/scsi/mpt3sas/mpt3sas_base.c +++ b/drivers/scsi/mpt3sas/mpt3sas_base.c @@ -4090,11 +4090,15 @@ _base_diag_reset(struct MPT3SAS_ADAPTER *ioc, int sleep_flag) writel(host_diagnostic | MPI2_DIAG_RESET_ADAPTER, &ioc->chip->HostDiagnostic); - /* don't access any registers for 50 milliseconds */ - msleep(50); + /*This delay allows the chip PCIe hardware time to finish reset tasks*/ + if (sleep_flag == CAN_SLEEP) + msleep(MPI2_HARD_RESET_PCIE_FIRST_READ_DELAY_MICRO_SEC/1000); + else + mdelay(MPI2_HARD_RESET_PCIE_FIRST_READ_DELAY_MICRO_SEC/1000); - /* 300 second max wait */ - for (count = 0; count < 3000000 ; count++) { + /* Approximately 300 second max wait */ + for (count = 0; count < (300000000 / + MPI2_HARD_RESET_PCIE_SECOND_READ_DELAY_MICRO_SEC); count++) { host_diagnostic = readl(&ioc->chip->HostDiagnostic); @@ -4103,11 +4107,13 @@ _base_diag_reset(struct MPT3SAS_ADAPTER *ioc, int sleep_flag) if (!(host_diagnostic & MPI2_DIAG_RESET_ADAPTER)) break; - /* wait 1 msec */ + /* Wait to pass the second read delay window */ if (sleep_flag == CAN_SLEEP) - usleep_range(1000, 1500); + msleep(MPI2_HARD_RESET_PCIE_SECOND_READ_DELAY_MICRO_SEC + / 1000); else - mdelay(1); + mdelay(MPI2_HARD_RESET_PCIE_SECOND_READ_DELAY_MICRO_SEC + / 1000); } if (host_diagnostic & MPI2_DIAG_HCB_MODE) { -- 1.7.3 -- To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
