On 05/23/2015 01:52 AM, Rajinikanth Pandurangan wrote: > -----Original Message----- > From: Tomas Henzl [mailto:[email protected]] > Sent: Friday, May 22, 2015 7:02 AM > To: Rajinikanth Pandurangan; [email protected]; > [email protected] > Cc: [email protected]; Harry Yang; Rich Bono; Achim Leubner; Murthy Bhat > Subject: Re: [PATCH 4/9] [SCSI] aacraid: Enable 64-bit write to controller > register > > On 05/14/2015 02:12 AM, [email protected] wrote: >> From: Rajinikanth Pandurangan <[email protected]> >> >> Description: >> If writeq() not supported, then do atomic two 32bit write >> >> Signed-off-by: Rajinikanth Pandurangan >> <[email protected]> >> --- >> drivers/scsi/aacraid/aacraid.h | 12 ++++++++++++ >> drivers/scsi/aacraid/comminit.c | 1 + >> drivers/scsi/aacraid/src.c | 12 ++++++++++-- >> 3 files changed, 23 insertions(+), 2 deletions(-) >> >> diff --git a/drivers/scsi/aacraid/aacraid.h >> b/drivers/scsi/aacraid/aacraid.h index 62b0999..9e69e3e 100644 >> --- a/drivers/scsi/aacraid/aacraid.h >> +++ b/drivers/scsi/aacraid/aacraid.h >> @@ -719,6 +719,9 @@ struct sa_registers { >> #define sa_readl(AEP, CSR) readl(&((AEP)->regs.sa->CSR)) >> #define sa_writew(AEP, CSR, value) writew(value, &((AEP)->regs.sa->CSR)) >> #define sa_writel(AEP, CSR, value) writel(value, &((AEP)->regs.sa->CSR)) >> +#if defined(writeq) >> +#define sa_writeq(AEP, CSR, value) writeq(value, >> &((AEP)->regs.sa->CSR)) > This^ is used nowhere, is it needed? > > [rajp] Yes, it's not needed. > >> +#endif >> >> /* >> * Rx Message Unit Registers >> @@ -844,6 +847,10 @@ struct src_registers { >> &((AEP)->regs.src.bar0->CSR)) >> #define src_writel(AEP, CSR, value) writel(value, \ >> &((AEP)->regs.src.bar0->CSR)) >> +#if defined(writeq) >> +#define src_writeq(AEP, CSR, value) writeq(value, \ >> + &((AEP)->regs.src.bar0->CSR)) >> +#endif >> >> #define SRC_ODR_SHIFT 12 >> #define SRC_IDR_SHIFT 9 >> @@ -1163,6 +1170,11 @@ struct aac_dev >> struct fsa_dev_info *fsa_dev; >> struct task_struct *thread; >> int cardtype; >> + /* >> + *This lock will protect the two 32-bit >> + *writes to the Inbound Queue >> + */ >> + spinlock_t iq_lock; >> >> /* >> * The following is the device specific extension. >> diff --git a/drivers/scsi/aacraid/comminit.c >> b/drivers/scsi/aacraid/comminit.c index 45a0a04..4043245 100644 >> --- a/drivers/scsi/aacraid/comminit.c >> +++ b/drivers/scsi/aacraid/comminit.c >> @@ -424,6 +424,7 @@ struct aac_dev *aac_init_adapter(struct aac_dev *dev) >> dev->management_fib_count = 0; >> spin_lock_init(&dev->manage_lock); >> spin_lock_init(&dev->sync_lock); >> + spin_lock_init(&dev->iq_lock); >> dev->max_fib_size = sizeof(struct hw_fib); >> dev->sg_tablesize = host->sg_tablesize = (dev->max_fib_size >> - sizeof(struct aac_fibhdr) >> diff --git a/drivers/scsi/aacraid/src.c b/drivers/scsi/aacraid/src.c >> index ae494c5..109863a 100644 >> --- a/drivers/scsi/aacraid/src.c >> +++ b/drivers/scsi/aacraid/src.c >> @@ -447,6 +447,10 @@ static int aac_src_deliver_message(struct fib *fib) >> u32 fibsize; >> dma_addr_t address; >> struct aac_fib_xporthdr *pFibX; >> +#if !defined(writeq) >> + unsigned long flags; >> +#endif >> + >> u16 hdr_size = le16_to_cpu(fib->hw_fib_va->header.Size); >> >> atomic_inc(&q->numpending); >> @@ -511,10 +515,14 @@ static int aac_src_deliver_message(struct fib *fib) >> return -EINVAL; >> address |= fibsize; >> } >> - >> +#if defined(writeq) >> + src_writeq(dev, MUnit.IQ_L, (u64)address); > What about just using the writeq directly without the macro ? > writeq(value, address); ? > > [Rajp] All other place we have macro. This is just for the uniformity. Okay, Tomas > >> +#else >> + spin_lock_irqsave(&fib->dev->iq_lock, flags); >> src_writel(dev, MUnit.IQ_H, upper_32_bits(address) & 0xffffffff); >> src_writel(dev, MUnit.IQ_L, address & 0xffffffff); >> - >> + spin_unlock_irqrestore(&fib->dev->iq_lock, flags); #endif >> return 0; >> } >> >> > > -- > To unsubscribe from this list: send the line "unsubscribe linux-scsi" in > the body of a message to [email protected] > More majordomo info at http://vger.kernel.org/majordomo-info.html >
-- To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
