On Thu, 2018-08-16 at 16:04 -0700, James Smart wrote:
> A recent change added some MDS processing in the lpfc_drain_txq
> routine that relies on the fcp_wq being allocated. For nvmet operation
> the fcp_wq is not allocated because it can only be an nvme-target.
> When the original MDS support was added LS_MDS_LOOPBACK was
> defined wrong, (0x16) it should have been 0x10 (decimal value used for
> hex setting). This incorrect value allowed MDS_LOOPBACK to be set
> simultaneously with LS_NPIV_FAB_SUPPORTED, causing the driver to
> crash when it accesses the non-existent fcp_wq.
>
> Correct the bad value setting for LS_MDS_LOOPBACK.
>
> Fixes: ae9e28f36a6c ("lpfc: Add MDS Diagnostic support.")
> Cc: <[email protected]> # 4.12
> Signed-off-by: Dick Kennedy <[email protected]>
> Signed-off-by: James Smart <[email protected]>
> ---
> drivers/scsi/lpfc/lpfc.h | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/scsi/lpfc/lpfc.h b/drivers/scsi/lpfc/lpfc.h
> index e0d0da5f43d6..43732e8d1347 100644
> --- a/drivers/scsi/lpfc/lpfc.h
> +++ b/drivers/scsi/lpfc/lpfc.h
> @@ -672,7 +672,7 @@ struct lpfc_hba {
> #define LS_NPIV_FAB_SUPPORTED 0x2 /* Fabric supports NPIV */
> #define LS_IGNORE_ERATT 0x4 /* intr handler should ignore ERATT */
> #define LS_MDS_LINK_DOWN 0x8 /* MDS Diagnostics Link Down */
> -#define LS_MDS_LOOPBACK 0x16 /* MDS Diagnostics Link Up (Loopback) */
> +#define LS_MDS_LOOPBACK 0x10 /* MDS Diagnostics Link Up (Loopback) */
>
> uint32_t hba_flag; /* hba generic flags */
> #define HBA_ERATT_HANDLED 0x1 /* This flag is set when eratt handled */
Fixes driver crash when lpfc_enable_nvmet used.
Tested-by: Ewan D. Milne <[email protected]>
