I having a problem with my new system: Tyan Thunder 2 with
the aic-7895 controller. I have a 8.7G U/W Micropolis drive
that I had been using with a PPro system(and aic-7880) with
no problems, but when I put it on my new system instead of
translating the number of heads/sectors/cylinders to
a reasonable number 255/63/1037 like the old system would
do, it leaves it at 64/32/8296 which causes problems with
lilo. Even though the two systems sees the drive differently,
I am still boot from it without reformating. It is currently
on 2.0.34. I faintly remember being able to specify the
harddrive parameters at the boot prompt and I tried
"sda=255,63,1037" without any luck. In the MB Bios I have
disabled the IDE totally. In the SCSI BIOS I have enabled
the option for >1G Drives but it seems to not affect it.
I am open for any ideas....
Thanks,
Mark
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
