Doug,
First of all, thanks for the response.
Here is the relative output from /proc/pci with the card installed under
2.2.10.
Bus 0, device 11, function 0:
SCSI storage controller: Adaptec Unknown device (rev 3).
Vendor id=9004. Device id=3860.
Medium devsel. Fast back-to-back capable. IRQ 9. Master Capable.
Latency=32. Min Gnt=4.Max Lat=4.
I/O at 0x6100 [0x6101].
Non-prefetchable 32 bit memory at 0xe4000000 [0xe4000000].
A modprobe aix7xxx results in this with the card installed:
/lib/modules/2.2.10/scsi/aic7xxx.o: init_module: Device or resource busy
Thanks again,
Chris Rhodes
[EMAIL PROTECTED]
On Mon, 21 Jun 1999 [EMAIL PROTECTED] wrote:
> Chris Rhodes wrote:
> >
> > Hello,
> >
> > Has anyone had any luck getting a 2930cu adaptec to work. I took a look
> > at aic7xxx.c in the 2.2.10 kernel and it does not appear to be
> > supported. If anyone can point me to something with even crude support
> > for this chipset revision, I would be most pleased.
>
> What does the aic7xxx driver say when you try to use it and what's the output
> of cat /proc/pci with that card installed.
>
> --
> Doug Ledford <[EMAIL PROTECTED]>
> Opinions expressed are my own, but
> they should be everybody's.
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
> the body of a message to [EMAIL PROTECTED]
>
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
