On Mon, 3 Apr 2000, Matthew Dharm wrote:
>Can an Ultra Wide SCSI-II drive operated when attached to a Fast Wide
>SCSI-II controller? I have this setup (all components purchased 2nd
>hand), and it's not working. I'm trying to figure out what part of all
>this (controller, cable, drive) is bad.
If (and that's really _IF_) the manufacture bothers to follow the rules
(read: the SCSI2 specs) then the answer is yes. All SCSI hardware is
_supposed_ to be fully backwards compatible all the way back to 5MHz,
8bit wide, async transfers. (That, btw, is the speed of the command
channel -- someone said 4MHz. Only the data in/out phases run at high(er)
speeds.)
That does not mean everyone follows the rules. I have a few IBM drives that
power up in LVD mode on a SE bus -- they aren't supposed to do that -- and
remain in LVD mode until they are addressed in a SE fashion; this trashes
the bus until they switch to SE (note: I have placed the idiot jumper on
them to force them into SE _always_.)
--Ricky
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
