Hello linux-setup,
Saya baru saja dapat driver motherboard bxcell 2000 terbaru..
ada driver sound for linux dan ada option untuk modem...(lihat di
cuplikan readme files)..
Kalau bener..modemku hsp akan bekerja...?? Wah kemenangan Linux.
Mohon bantuannya..pencerahan untuk perintah perintah yang diberikan
oleh readmenya ini..(terus terang saja..tidak satupun perintah dibawah
ini saya mengerti)
----The ReadMe files ----
Audio driver for CM8338/CM8738 chips by Chen-Li Tien
STEPS TO BUILD DRIVER
================================================================================
1. Backup the Config.in and Makefile in the sound driver directory
(/usr/src/linux/driver/sound).
2. Extract the tar file by 'tar xvzf cmpci-xx.tar.gz' in the above
directory.
3. Change directory to /usr/src/linux
4. Config cm8338 driver by 'make menuconfig', 'make config' or
'make xconfig' command.
5. Please select Sound Card (CONFIG_SOUND=m) support and CMPCI
driver (CONFIG_SOUND_CMPCI=m) as modules. Resident mode not tested.
For driver option, please refer 'DRIVER PARAMETER'
6. Compile the kernel if necessary.
7. Compile the modules by 'make modules'.
8. Install the modules by 'make modules_install'
INSTALL DRIVER
================================================================================
1. Before first time to run the driver, create module dependency by
'depmod -a'
2. To install the driver manually, enter 'modprobe cmpci'.
3. Driver installation for various distributions:
a. Slackware 4.0
Add the 'modprobe cmpci' command in your /etc/rc.d/rc.modules
file.so you can start the driver automatically each time booting.
b. Caldera OpenLinux 2.2
Use LISA to load the cmpci module.
c. RedHat 6.0 and S.u.S.E. 6.1
Add following command in /etc/conf.modules:
alias char-major-14 cmpci
DRIVER PARAMETER
================================================================================
Some functions for the cm8738 can be configured in Kernel Configuration
or modules parameters. Set these parameters to 1 to enable.
spdif_loop: Enable S/PDIF loop, this route S/PDIF-in to S/PDIF-out
directly.
four_ch: Enable 4 channels mode, rear-out or line-in will output
the same as line-out.
rear_out: Enable this if you have independent rear-out jacket on
your sound card, otherwise line-in will be used as
rear-out.
modem: You will need to set this parameter if you want to use
^^^^^^^ the HSP modem. You need install the pctel.o, the modem
driver itself.
--------------------------------------------------------------------------
Utk berhenti langganan, kirim email ke [EMAIL PROTECTED]
Informasi arsip di http://www.linux.or.id/milis.php3
Pengelola dapat dihubungi lewat [EMAIL PROTECTED]
