Hi!
I still have the aic7xxx-driver problem with the new kernels (2.1.125,
2.1.126). While booting, the driver scans all scsi-id's and fins my
Segate Barracuda at id 0. Then I get a lot of time-outs while the driver
tries to scan the other id's. My boot-device is a scsi-drive, so I
cannot try the driver as a module. Maybe this is a smp-problem because
nobody complained about that on the scsi mailing-list yet. I have
updated the BIOS and checked the termination, this did not help.
(2.1.124 works fine!!)
This is my System:
Asus P2L97-DS Board
(scsi0) <Adaptec AIC-7880 Ultra SCSI host adapter> found at PCI 6/0
SCSI Adapter: Adaptec AIC-7880 Ultra SCSI host adapter
Ultra Wide Controller
PCI MMAPed I/O Base: 0xe0800000
Adaptec SCSI BIOS: Enabled
IRQ: 9
SCBs: Active 0, Max Active 1,
Allocated 30, HW 16, Page 255
Host: scsi0 Channel: 00 Id: 00 Lun: 00
Vendor: SEAGATE Model: ST34572W Rev: 0784
Type: Direct-Access ANSI SCSI revision: 02
Hope someone finds the problem...
Matthias
