> Matched steps and stamps ?
> Fried sense pin on both or only one ??
> 4*100 or 6*66 ???
Whoops, forgot about that in the last message :) 6*66, no turbo freq
enabled. And in case you care --
klogd 1.3-3#33, log source = /proc/kmsg started.
Inspecting /System.map-2.3.19mingo-H3
Loaded 9150 symbols from /System.map-2.3.19mingo-H3.
Symbols match kernel version 2.3.19.
No module symbols loaded.
Linux version 2.3.19mingo-H3
(root@solvent) (gcc version 2.95.2 19990906 (prerelease)) #6 SMP Thu Oct
7 18:11:14 EDT 1999
e820: 654336 @ 00000000 (usable)
e820: 1024 @ 0009fc00 (reserved)
e820: 65536 @ 000f0000 (reserved)
e820: 4096 @ fec00000 (reserved)
e820: 4096 @ fee00000 (reserved)
e820: 65536 @ ffff0000 (reserved)
e820: 133169152 @ 00100000 (usable)
Scan SMP from c0000000 for 1024 bytes.
Scan SMP from c009fc00 for 1024 bytes.
Scan SMP from c00f0000 for 65536 bytes.
found SMP MP-table at 01006384
Intel MultiProcessor Specification v1.1
Virtual Wire compatibility mode.
OEM ID: OEM00000 Product ID: PROD00000000 APIC at: 0xFEE00000
Processor #0 Pentium(tm) Pro APIC version 17
Floating point unit present.
Machine Exception supported.
64 bit compare & exchange supported.
Internal APIC present.
Bootup CPU
Processor #1 Pentium(tm) Pro APIC version 17
Floating point unit present.
Machine Exception supported.
64 bit compare & exchange supported.
Internal APIC present.
Bus #0 is PCI
Bus #1 is PCI
Bus #2 is ISA
I/O APIC #2 Version 17 at 0xFEC00000.
Processors: 2
mapped APIC to ffffe000 (fee00000)
mapped IOAPIC to ffffd000 (fec00000)
Detected 400918609 Hz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 399.77 BogoMIPS
memory region: 639k @ 00000000
memory region: 130048k @ 00100000
Memory: 126556k/131072k available (1296k kernel code, 428k reserved,
2716k data, 76k init, 0k bigmem)
Buffer-cache hash table entries: 8192
(order: 3, 32768 bytes)
Page-cache hash table entries: 32768
(order: 5, 131072 bytes)
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35 (19990512) Richard Gooch ([EMAIL PROTECTED])
per-CPU timeslice cutoff: 25.05 usecs.
CPU0: Intel Celeron (Mendocino) stepping 05
Getting VERSION: 40011
Getting VERSION: 40011
Getting LVT0: 700
Getting LVT1: 400
enabled ExtINT on CPU#0
ESR value before enabling vector: 00000000
ESR value after enabling vector: 00000000
CPU map: 3
Booting processor 1 eip 2000
Setting warm reset code and vector.
1.
2.
3.
Asserting INIT.
Deasserting INIT.
Sending STARTUP #1.
After apic_write.
Startup point 1.
Waiting for send to finish...
+Initializing CPU#1
CPU#1 waiting for CALLOUT
Sending STARTUP #2.
After apic_write.
Startup point 1.
Waiting for send to finish...
+After Startup.
Before Callout 1.
After Callout 1.
CALLIN, before setup_local_APIC().
masked ExtINT on CPU#1
ESR value before enabling vector: 00000000
ESR value after enabling vector: 00000000
Calibrating delay loop... 400.59 BogoMIPS
Stack at about c0507fb4
OK.
CPU1: Intel Celeron (Mendocino) stepping 05
CPU has booted.
Before bogomips.
Total of 2 processors activated (800.36 BogoMIPS).
Before bogocount - setting activated=1.
Boot done.
ENABLING IO-APIC IRQs
init IO_APIC IRQs
IO-APIC (apicid-pin) 2-0, 2-20, 2-21, 2-22, 2-23 not connected.
activating NMI Watchdog ...smp_call(), cpus:1
done.
number of MP IRQ sources: 23.
number of IO-APIC #2 registers: 24.
testing the IO APIC.......................
IO APIC #2......
.... register #00: 02000000
....... : physical APIC id: 02
.... register #01: 00170011
....... : max redirection entries: 0017
....... : IO APIC version: 0011
.... register #02: 00000000
....... : arbitration: 00
.... IRQ redirection table:
NR Log Phy Mask Trig IRR Pol Stat Dest Deli Vect:
00 000 00 1 0 0 0 0 0 0 00
01 0FF 0F 0 0 0 0 0 1 1 59
02 0FF 0F 0 0 0 0 0 1 1 51
03 0FF 0F 0 0 0 0 0 1 1 61
04 0FF 0F 0 0 0 0 0 1 1 69
05 0FF 0F 0 0 0 0 0 1 1 71
06 0FF 0F 0 0 0 0 0 1 1 79
07 0FF 0F 0 0 0 0 0 1 1 81
08 0FF 0F 0 0 0 0 0 1 1 89
09 0FF 0F 0 0 0 0 0 1 1 91
0a 0FF 0F 0 0 0 0 0 1 1 99
0b 0FF 0F 0 0 0 0 0 1 1 A1
0c 0FF 0F 0 0 0 0 0 1 1 A9
0d 000 00 1 0 0 0 0 0 0 00
0e 0FF 0F 0 0 0 0 0 1 1 B1
0f 0FF 0F 0 0 0 0 0 1 1 B9
10 0FF 0F 1 1 0 1 0 1 1 C1
11 0FF 0F 1 1 0 1 0 1 1 C9
12 0FF 0F 1 1 0 1 0 1 1 D1
13 0FF 0F 1 1 0 1 0 1 1 D9
14 000 00 1 0 0 0 0 0 0 00
15 000 00 1 0 0 0 0 0 0 00
16 000 00 1 0 0 0 0 0 0 00
17 000 00 1 0 0 0 0 0 0 00
IRQ to pin mappings:
IRQ0 -> 2
IRQ1 -> 1
IRQ3 -> 3
IRQ4 -> 4
IRQ5 -> 5
IRQ6 -> 6
IRQ7 -> 7
IRQ8 -> 8
IRQ9 -> 9
IRQ10 -> 10
IRQ11 -> 11
IRQ12 -> 12
IRQ13 -> 13
IRQ14 -> 14
IRQ15 -> 15
IRQ16 -> 16
IRQ17 -> 17
IRQ18 -> 18
IRQ19 -> 19
.................................... done.
Initializing CPU#0
calibrating APIC timer ...
..... CPU clock speed is 400.9192 MHz.
..... host bus clock speed is 66.8196 MHz.
smp_call(), cpus:1
cpu: 1, clocks: 668196, slice: 222732, nr: 2.
CPU1<C0:668192,C:222720,D:8,S:222732,C:668196>
cpu: 0, clocks: 668196, slice: 222732, nr: 1.
CPU0<C0:668192,C:445456,D:4,S:222732,C:668196>
checking TSC synchronization across CPUs: passed.
Setting commenced=1, go go go
PCI: PCI BIOS revision 2.10 entry at 0xfb420
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI->APIC IRQ transform: (B0,I9,P0) -> 19
PCI->APIC IRQ transform: (B0,I9,P0) -> 19
PCI->APIC IRQ transform: (B0,I13,P0) -> 17
PCI->APIC IRQ transform: (B0,I19,P0) -> 18
PCI->APIC IRQ transform: (B0,I19,P1) -> 18
PCI->APIC IRQ transform: (B1,I0,P0) -> 16
isapnp: Scanning for Pnp cards...
isapnp: Card 'Creative SB AWE64 PnP'
isapnp: 1 Plug & Play card detected total
Linux NET4.0 for Linux 2.3
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
TCP: Hash tables configured (established 8192 bind 8192)
Starting kswapd v1.6
parport0: PC-style at 0x378 [PCSPP,TRISTATE]
parport0: cpp_mux: aa55f00f52ad51(87)
parport0: cpp_daisy: aa5500ff(80)
parport0: assign_addrs: aa5500ff(80)
Detected PS/2 Mouse Port.
Serial driver version 4.30 with SHARE_IRQ SERIAL_PCI PCI_IOMEM enabled
ttyS01 at 0x02f8 (irq = 3) is a 16550A
pty: 256 Unix98 ptys configured
lp0: using parport0 (polling).
Software Watchdog Timer: 0.05, timer margin: 60 sec
Real Time Clock Driver v1.09a
Sound initialization started
<Sound Blaster 16 (4.16)> at 0x220 irq 5 dma 1,5
<Sound Blaster 16> at 0x330 irq 5 dma 0
<Yamaha OPL3> at 0x388
AWE32: not detected
Sound initialization complete
js: Version 1.2.13 using 400 MHz RDTSC timer.
js0: SideWinder GamePad at 0x201
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
(scsi0) <Adaptec AHA-294X Ultra SCSI host adapter> found at PCI 13/0
(scsi0) Wide Channel, SCSI ID=7, 16/255 SCBs
(scsi0) Warning - detected auto-termination
(scsi0) Please verify driver detected settings are correct.
(scsi0) If not, then please properly set the device termination
(scsi0) in the Adaptec SCSI BIOS by hitting CTRL-A when prompted
(scsi0) during machine bootup.
(scsi0) Cables present (Int-50 YES, Int-68 NO, Ext-68 NO)
(scsi0) Downloading sequencer code... 413 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.19/3.2.4
<Adaptec AHA-294X Ultra SCSI host adapter>
scsi : 1 host.
(scsi0:0:0:0) Synchronous at 20.0 Mbyte/sec, offset 15.
Vendor: QUANTUM Model: FIREBALL ST3.2S Rev: 0F0C
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
(scsi0:0:1:0) Synchronous at 20.0 Mbyte/sec, offset 15.
Vendor: QUANTUM Model: FIREBALL SE6.4S Rev: PJ0A
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdb at scsi0, channel 0, id 1, lun 0
(scsi0:0:6:0) Synchronous at 10.0 Mbyte/sec, offset 8.
Vendor: TOSHIBA Model: CD-ROM XM-5701TA Rev: 0167
Type: CD-ROM ANSI SCSI revision: 02
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0
scsi : detected 1 SCSI cdrom 2 SCSI disks total.
Uniform CDROM driver Revision: 3.04
SCSI device sda: hdwr sector= 512 bytes.
Sectors= 6328861 [3090 MB] [3.1 GB]
SCSI device sdb: hdwr sector= 512 bytes.
Sectors= 12594960 [6149 MB] [6.1 GB]
PPP generic driver version 2.4.0
PPP Deflate compression module registered
Partition check:
sda: sda1 sda2
sdb: sdb1 sdb2
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 76k freed
Adding Swap: 128516k swap-space (priority -1)
--Ian Ehrenwald
-
Linux SMP list: FIRST see FAQ at http://www.irisa.fr/prive/mentre/smp-faq/
To Unsubscribe: send "unsubscribe linux-smp" to [EMAIL PROTECTED]
