Is this enough info?
It's a Compaq SP 750 with a freshly installed RH 6.1.
CPU1: Intel Pentium III (Coppermine) stepping 01
calibrating APIC timer ...
..... CPU clock speed is 731.0207 MHz.
..... system bus clock speed is 132.9126 MHz.
Booting processor 0 eip 2000
Calibrating delay loop... 730.73 BogoMIPS
OK.
CPU0: Intel Pentium III (Coppermine) stepping 01
Total of 2 processors activated (1459.81 BogoMIPS).
enabling symmetric IO mode... ...done.
ENABLING IO-APIC IRQs
init IO_APIC IRQs
IO-APIC (apicid-pin) 8-0, 8-2, 8-11, 8-20, 8-21, 8-22, 8-23 not connected.
...trying to set up timer as ExtINT... failed.
...trying to set up timer as BP IRQ... works.
number of MP IRQ sources: 47.
number of IO-APIC #8 registers: 24.
testing the IO APIC.......................
IO APIC #8......
.... register #00: 00000000
....... : physical APIC id: 00
.... register #01: 00170020
....... : max redirection entries: 0017
....... : IO APIC version: 0020
WARNING: unexpected IO-APIC, please mail
to [EMAIL PROTECTED]
.... register #02: 02000000
....... : arbitration: 02
.... IRQ redirection table:
NR Log Phy Mask Trig IRR Pol Stat Dest Deli Vect:
00 000 00 1 0 0 0 0 0 0 00
01 000 00 0 0 0 0 0 1 1 59
02 000 00 1 0 0 0 0 0 0 00
03 000 00 0 0 0 0 0 1 1 61
04 000 00 0 0 0 0 0 1 1 69
05 000 00 0 0 0 0 0 1 1 71
06 000 00 0 0 0 0 0 1 1 79
07 000 00 0 0 0 0 0 1 1 81
08 000 00 0 0 0 0 0 1 1 89
09 000 00 0 0 0 0 0 1 1 91
0a 000 00 0 0 0 0 0 1 1 99
0b 000 00 1 0 0 0 0 0 0 00
0c 000 00 0 0 0 0 0 1 1 A1
0d 000 00 1 0 0 0 0 0 0 00
0e 000 00 0 0 0 0 0 1 1 A9
0f 000 00 0 0 0 0 0 1 1 B1
10 0FF 0F 1 1 0 1 0 1 1 B9
11 0FF 0F 1 1 0 1 0 1 1 C1
12 0FF 0F 1 1 0 1 0 1 1 C9
13 0FF 0F 1 1 0 1 0 1 1 D1
14 000 00 1 0 0 0 0 0 0 00
15 000 00 1 0 0 0 0 0 0 00
16 000 00 1 0 0 0 0 0 0 00
17 000 00 1 0 0 0 0 0 0 00
IRQ to pin mappings:
IRQ1 -> 1
IRQ3 -> 3
IRQ4 -> 4
IRQ5 -> 5
IRQ6 -> 6
IRQ7 -> 7
IRQ8 -> 8
IRQ9 -> 9
IRQ10 -> 10
IRQ12 -> 12
IRQ13 -> 13
IRQ14 -> 14
IRQ15 -> 15
IRQ16 -> 16
IRQ17 -> 17
IRQ18 -> 18
IRQ19 -> 19
.................................... done.
PCI: PCI BIOS revision 2.10 entry at 0xedb12
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI->APIC IRQ transform: (B0,I31,P3) -> 19
PCI->APIC IRQ transform: (B0,I31,P1) -> 17
PCI->APIC IRQ transform: (B0,I31,P1) -> 17
PCI: Enabling memory for device 01:00
PCI->APIC IRQ transform: (B1,I0,P0) -> 18
PCI->APIC IRQ transform: (B4,I2,P0) -> 18
PCI->APIC IRQ transform: (B4,I7,P0) -> 19
PCI->APIC IRQ transform: (B4,I7,P1) -> 16
PCI: Enabling memory for device 04:41
PCI->APIC IRQ transform: (B4,I8,P0) -> 16
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
-
Linux SMP list: FIRST see FAQ at http://www.irisa.fr/prive/dmentre/smp-howto/
To Unsubscribe: send "unsubscribe linux-smp" to [EMAIL PROTECTED]
