Set bits_per_word_mask so spi core will reject transfers that attempt to use an unsupported bits_per_word value.
Signed-off-by: Axel Lin <[email protected]> --- drivers/spi/spi-omap-uwire.c | 18 ++---------------- 1 file changed, 2 insertions(+), 16 deletions(-) diff --git a/drivers/spi/spi-omap-uwire.c b/drivers/spi/spi-omap-uwire.c index 462ddd4..95cc694 100644 --- a/drivers/spi/spi-omap-uwire.c +++ b/drivers/spi/spi-omap-uwire.c @@ -99,7 +99,6 @@ struct uwire_spi { }; struct uwire_state { - unsigned bits_per_word; unsigned div1_idx; }; @@ -210,9 +209,8 @@ static void uwire_chipselect(struct spi_device *spi, int value) static int uwire_txrx(struct spi_device *spi, struct spi_transfer *t) { - struct uwire_state *ust = spi->controller_state; unsigned len = t->len; - unsigned bits = ust->bits_per_word; + unsigned bits = t->bits_per_word ? : spi->bits_per_word; unsigned bytes; u16 val, w; int status = 0; @@ -322,7 +320,6 @@ static int uwire_setup_transfer(struct spi_device *spi, struct spi_transfer *t) struct uwire_state *ust = spi->controller_state; struct uwire_spi *uwire; unsigned flags = 0; - unsigned bits; unsigned hz; unsigned long rate; int div1_idx; @@ -332,17 +329,6 @@ static int uwire_setup_transfer(struct spi_device *spi, struct spi_transfer *t) uwire = spi_master_get_devdata(spi->master); - bits = spi->bits_per_word; - if (t != NULL && t->bits_per_word) - bits = t->bits_per_word; - - if (bits > 16) { - pr_debug("%s: wordsize %d?\n", dev_name(&spi->dev), bits); - status = -ENODEV; - goto done; - } - ust->bits_per_word = bits; - /* mode 0..3, clock inverted separately; * standard nCS signaling; * don't treat DI=high as "not ready" @@ -509,7 +495,7 @@ static int uwire_probe(struct platform_device *pdev) /* the spi->mode bits understood by this driver: */ master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH; - + master->bits_per_word_mask = SPI_BPW_RANGE_MASK(1, 16); master->flags = SPI_MASTER_HALF_DUPLEX; master->bus_num = 2; /* "official" */ -- 1.8.1.2 -- To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
