Extend the driver to make full use of runtime PM autosuspend.
Before only the SPI core was instructed to use autosuspend
by setting master->auto_runtime_pm. Nevertheless due to the missing
pm_runtime_use_autosuspend call autosuspend wasn't active.

Signed-off-by: Heiner Kallweit <[email protected]>
---
Changed:
- Let driver autosuspend also after leaving s3c64xx_spi_setup
- Enable runtime PM earlier in s3c64xx_spi_probe and prevent
  suspending in the relevant part of probe
v2:
- Don't init runtime PM before the driver has a reference to the clocks

 drivers/spi/spi-s3c64xx.c | 26 ++++++++++++++++++--------
 1 file changed, 18 insertions(+), 8 deletions(-)

diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
index 8a6ab88..d117fa6 100644
--- a/drivers/spi/spi-s3c64xx.c
+++ b/drivers/spi/spi-s3c64xx.c
@@ -32,6 +32,7 @@
 #define MAX_SPI_PORTS          6
 #define S3C64XX_SPI_QUIRK_POLL         (1 << 0)
 #define S3C64XX_SPI_QUIRK_CS_AUTO      (1 << 1)
+#define AUTOSUSPEND_TIMEOUT    2000
 
 /* Registers and bit-fields */
 
@@ -859,13 +860,15 @@ static int s3c64xx_spi_setup(struct spi_device *spi)
                }
        }
 
-       pm_runtime_put(&sdd->pdev->dev);
+       pm_runtime_mark_last_busy(&sdd->pdev->dev);
+       pm_runtime_put_autosuspend(&sdd->pdev->dev);
        if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
                writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + 
S3C64XX_SPI_SLAVE_SEL);
        return 0;
 
 setup_exit:
-       pm_runtime_put(&sdd->pdev->dev);
+       pm_runtime_mark_last_busy(&sdd->pdev->dev);
+       pm_runtime_put_autosuspend(&sdd->pdev->dev);
        /* setup() returns with device de-selected */
        if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
                writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + 
S3C64XX_SPI_SLAVE_SEL);
@@ -1162,6 +1165,12 @@ static int s3c64xx_spi_probe(struct platform_device 
*pdev)
                goto err2;
        }
 
+       pm_runtime_set_autosuspend_delay(&pdev->dev, AUTOSUSPEND_TIMEOUT);
+       pm_runtime_use_autosuspend(&pdev->dev);
+       pm_runtime_set_active(&pdev->dev);
+       pm_runtime_enable(&pdev->dev);
+       pm_runtime_get_sync(&pdev->dev);
+
        /* Setup Deufult Mode */
        s3c64xx_spi_hwinit(sdd, sdd->port_id);
 
@@ -1180,13 +1189,10 @@ static int s3c64xx_spi_probe(struct platform_device 
*pdev)
               S3C64XX_SPI_INT_TX_OVERRUN_EN | S3C64XX_SPI_INT_TX_UNDERRUN_EN,
               sdd->regs + S3C64XX_SPI_INT_EN);
 
-       pm_runtime_set_active(&pdev->dev);
-       pm_runtime_enable(&pdev->dev);
-
        ret = devm_spi_register_master(&pdev->dev, master);
        if (ret != 0) {
                dev_err(&pdev->dev, "cannot register SPI master: %d\n", ret);
-               goto err4;
+               goto err3;
        }
 
        dev_dbg(&pdev->dev, "Samsung SoC SPI Driver loaded for Bus SPI-%d with 
%d Slaves attached\n",
@@ -1195,12 +1201,16 @@ static int s3c64xx_spi_probe(struct platform_device 
*pdev)
                                        mem_res, (FIFO_LVL_MASK(sdd) >> 1) + 1,
                                        sdd->rx_dma.dmach, sdd->tx_dma.dmach);
 
+       pm_runtime_mark_last_busy(&pdev->dev);
+       pm_runtime_put_autosuspend(&pdev->dev);
+
        return 0;
 
-err4:
+err3:
+       pm_runtime_put_noidle(&pdev->dev);
        pm_runtime_disable(&pdev->dev);
        pm_runtime_set_suspended(&pdev->dev);
-err3:
+
        clk_disable_unprepare(sdd->src_clk);
 err2:
        clk_disable_unprepare(sdd->clk);
-- 
2.5.0


--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to