Hi all, I am trying to install imagesfrom SD card to internal nand, first of all I need to locate the internal nand device /dev/nand, however I could not.
dmesg reveals that something went wrong when the driver loaded: here are the error messages: [ 0.424664] [NAND] nand driver version: 0x2 0x9 [ 0.431936] PHY_PageReadSpare : too much ecc err,bank 0 block 7,page 0 ... ...(tons of them) [ 3.659593] PHY_PageReadSpare : too much ecc err,bank 0 block 7ff,page 0 [ 3.664674] [FORMAT_ERR] There is not enough valid block for using! [ 3.670086] [FORMAT_ERR] There is not enough free blocks for distribute! [ 3.673509] [FORMAT_ERR] Format nand disk failed! [ 3.675872] [NAND]init_blklayer fail Any idea what's going on? Is the nand driver 0x2 0x9 itself buggy? or something else? the stock Android runs well on the internal NAND, I doubt this is a real hardware failure? I also tried using Livesuit to reflash Android again, but after which it was the same dmesg. Thanks, -Hunter -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
