Hi,
On 15-02-15 11:49, [email protected] wrote:
Hi,
thanks for your work - these are very good news :)
Just one question - i think NOP_USB_XCEIV should be selected to make it
work or am i wrong?
You're right, I should fix this in the Kconfig rules.
Regards,
Hans
Tobias
Am Freitag, 13. Februar 2015 20:25:59 UTC+1 schrieb Hans de Goede:
Hi All,
I'm happy to report that after a lot of poking at the Allwinner
musb code I've it working reliable in both host and peripheral mode,
as well as automatically switching between the 2 depending on which
cable gets plugged.
My wip code is available here:
https://github.com/jwrdegoede/linux-sunxi/commits/sunxi-wip
Functionality wise this is complete and I expect / hope there will be
no functional changes before it goes upstream.
There are 2 things which need to be done before it can be submitted
upstream though:
1) All the ForceVbus / ForceID stuff needs to be cleaned up
2) Currently this is not suitable for multiplatform kernels as it
puts a #ifdef MACH_SUNXI in musb_regs.h, this needs to be fixed.
1) is just a matter of removing a whole lot of unnecessary indirection
in the code, and giving the relevant defines better names
2) I've a plan for, I just need some time for this.
I've so far only tested this on a cubietruck, I started development on
a cubieboard, but the cubieboard has the Vusb hardwired to the 5V of the
board (or at least mine does) meaning that the Vusb enable gpio does not
do anything, and Vusb-detect always reads as 1, I think my current code
may work despite this, but I need to test.
Note that the dts modifications for the cubietruck / cubieboard enable
the musb controller in otg mode, which means that it will not "start"
until a gadget driver is loaded. For testing I use:
insmod libcomposite.ko
insmod u_serial.ko
insmod usb_f_acm.ko
insmod g_serial.ko
After this you should see 2 messages like this:
[ 3528.872816] g_serial gadget: Gadget Serial v2.4
[ 3528.877377] g_serial gadget: g_serial ready
And then the controller should work either as a usb serial
port (ttyGS0 on cubietruck side, ttyACM0 on pc version)
or as a usb host, depending on what you plug in, and you should
be able to switch on the fly.
I use the following on the cubietruck side to start a getty
on the usb serial, this assumes you use systemd :)
systemctl start [email protected]
If you put this in say rc.local, then you can use it to
get a console on a tablet over the otg connector, which is
very useful for debugging stuff.
Regards,
Hans
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
