Am 20.02.2015 um 14:47 schrieb Simo Xefil:
Hello,
I've installed 'libvdpau-sunxi' on an A20 board having mali400 gpu.
Until here all ok. In this way I'm able to play video smooth using HW
decoding vdpau with mplayer or mpv.
To do that I need to have an X11 display, or I get an error. Is there
a way to obtain the same result sendig the video to framebuffer in a
virtual-console without X11 or I'm asking something impossible?
libvdpau-sunxi as vdpau in general depend on X, so no, it's not possible
to directly access framebuffer.
AFAYK in mplayer the "-vc" is used to set the video codec, and it's
set-up to be 'ffmpeg12vdpau,ffh264vdpau'.
The "-vo" is used to set the video output device. Following your
documentation I need to set it to "vdpau".
Would it be possible to send it so to framebuffer or modified sdl2
that uses framebuffer?
I know could be more an mplayer/mpv-mailinglist question but it's only
to know it it's something that makes sense.
Thanks!
Simon
Regards
Andreas
--
You received this message because you are subscribed to the Google
Groups "linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send
an email to [email protected]
<mailto:[email protected]>.
For more options, visit https://groups.google.com/d/optout.
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
