Hi Maxime,
This series enables support for the Sinlinx SinA33 dev board. This
is a core/daughter board SDK kit from Chinese vendor Sinlinx. The
core board itself does not have any special connectivity, so I
didn't split them into 2 files.
The series is based on Vishnu/Hans' A33 series (v2). As the last
(dts) patch was not merged yet, there might be a conflict in
dts/Makefile.
Patch 1 adds a pinmux setting for uart0 on PB pins. This is new on
A33, and is much better than using R_UART for console on A23, as
we can also see messages from BROM/boot0 when developing, and also
use the same earlyprintk settings as other sunxi platforms.
Patch 2 adds a pinmux setting for 8 bit eMMC on mmc2.
mmc2 also has a reset pin, though I'm not sure if our mmc driver
actually uses it. Not using it seems to work anyway.
Patch 3 adds the dts file for the SinA33 dev board. Just the basic
set of features are enabled: UART console, MMC, LRADC.
Chen-Yu Tsai (3):
ARM: dts: sun8i: Add pinmux setting for 8bit mmc2
ARM: dts: sun8i-a33: Add pinmux setting for uart0 on PB pins
ARM: dts: sun8i-a33: Add dts for Sinlinx SinA33 development board.
arch/arm/boot/dts/Makefile | 3 +-
arch/arm/boot/dts/sun8i-a23-a33.dtsi | 10 ++
...sun8i-a33.dtsi => sun8i-a33-sinlinx-sina33.dts} | 106 ++++++++++++++-------
arch/arm/boot/dts/sun8i-a33.dtsi | 8 ++
4 files changed, 93 insertions(+), 34 deletions(-)
copy arch/arm/boot/dts/{sun8i-a33.dtsi => sun8i-a33-sinlinx-sina33.dts} (56%)
--
2.1.4
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
