The AXP809 PMIC is the primary PMIC. It provides various supply voltages for the SoC and other peripherals. The PMIC's interrupt line is connected to NMI pin of the SoC.
Signed-off-by: Chen-Yu Tsai <[email protected]> --- arch/arm/boot/dts/sun9i-a80-cubieboard4.dts | 131 +++++++++++++++++++++++++++- 1 file changed, 129 insertions(+), 2 deletions(-) diff --git a/arch/arm/boot/dts/sun9i-a80-cubieboard4.dts b/arch/arm/boot/dts/sun9i-a80-cubieboard4.dts index eb2ccd0a3bd5..8d8af1189d87 100644 --- a/arch/arm/boot/dts/sun9i-a80-cubieboard4.dts +++ b/arch/arm/boot/dts/sun9i-a80-cubieboard4.dts @@ -98,7 +98,7 @@ &mmc0 { pinctrl-names = "default"; pinctrl-0 = <&mmc0_pins>, <&mmc0_cd_pin_cubieboard4>; - vmmc-supply = <®_vcc3v0>; + vmmc-supply = <®_dcdc1>; bus-width = <4>; cd-gpios = <&pio 7 18 GPIO_ACTIVE_HIGH>; /* PH18 */ cd-inverted; @@ -108,7 +108,7 @@ &mmc2 { pinctrl-names = "default"; pinctrl-0 = <&mmc2_8bit_pins>; - vmmc-supply = <®_vcc3v0>; + vmmc-supply = <®_dcdc1>; bus-width = <8>; non-removable; cap-mmc-hw-reset; @@ -126,8 +126,135 @@ &r_rsb { status = "okay"; + + axp809: pmic@3a3 { + reg = <0x3a3>; + interrupt-parent = <&nmi_intc>; + interrupts = <0 IRQ_TYPE_LEVEL_LOW>; + + regulators { + reg_aldo1: aldo1 { + /* + * TODO: This should be handled by the + * USB PHY driver. + */ + regulator-always-on; + regulator-min-microvolt = <3000000>; + regulator-max-microvolt = <3000000>; + regulator-name = "vcc33-usbh"; + }; + + reg_aldo2: aldo2 { + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <1800000>; + regulator-name = "vcc-pb-io-cam"; + }; + + aldo3 { + /* unused */ + }; + + reg_dc5ldo: dc5ldo { + regulator-always-on; + regulator-min-microvolt = <800000>; + regulator-max-microvolt = <1100000>; + regulator-name = "vdd-cpus-09-usbh"; + }; + + reg_dcdc1: dcdc1 { + regulator-always-on; + regulator-min-microvolt = <3000000>; + regulator-max-microvolt = <3000000>; + regulator-name = "vcc-3v"; + }; + + reg_dcdc2: dcdc2 { + regulator-min-microvolt = <800000>; + regulator-max-microvolt = <1100000>; + regulator-name = "vdd-gpu"; + }; + + reg_dcdc3: dcdc3 { + regulator-always-on; + regulator-min-microvolt = <800000>; + regulator-max-microvolt = <1100000>; + regulator-name = "vdd-cpua"; + }; + + reg_dcdc4: dcdc4 { + regulator-always-on; + regulator-min-microvolt = <800000>; + regulator-max-microvolt = <1100000>; + regulator-name = "vdd-sys-usb0-hdmi"; + }; + + reg_dcdc5: dcdc5 { + regulator-always-on; + regulator-min-microvolt = <1425000>; + regulator-max-microvolt = <1575000>; + regulator-name = "vcc-dram"; + }; + + reg_dldo1: dldo1 { + /* + * The WiFi chip supports a wide range + * (3.0 ~ 4.8V) of voltages, and so does + * this regulator (3.0 ~ 4.2V), but + * Allwinner SDK always sets it to 3.3V. + */ + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + regulator-name = "vcc-wifi"; + }; + + reg_dldo2: dldo2 { + regulator-always-on; + regulator-min-microvolt = <3000000>; + regulator-max-microvolt = <3000000>; + regulator-name = "vcc-pl"; + }; + + reg_eldo1: eldo1 { + regulator-min-microvolt = <1200000>; + regulator-max-microvolt = <1200000>; + regulator-name = "vcc-dvdd-cam"; + }; + + reg_eldo2: eldo2 { + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <1800000>; + regulator-name = "vcc-pe"; + }; + + reg_eldo3: eldo3 { + regulator-always-on; + regulator-min-microvolt = <3000000>; + regulator-max-microvolt = <3000000>; + regulator-name = "vcc-pm-codec-io1"; + }; + + reg_ldo_io0: ldo_io0 { + regulator-always-on; + regulator-min-microvolt = <3000000>; + regulator-max-microvolt = <3000000>; + regulator-name = "vcc-pg"; + }; + + reg_ldo_io1: ldo_io1 { + regulator-min-microvolt = <2500000>; + regulator-max-microvolt = <2500000>; + regulator-name = "vcc-pa-gmac-2v5"; + }; + + reg_rtc_ldo: rtc_ldo { + regulator-name = "vcc-rtc-vdd1v8-io"; + }; + }; + }; }; +#include "axp809.dtsi" + &uart0 { pinctrl-names = "default"; pinctrl-0 = <&uart0_pins_a>; -- 2.7.0 -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
