Banana Pi M2 Ultra has a SATA port connected to the internal SATA controller of R40 SoC. The controller's 1.2v VDD is connected to ELDO3 and the 2.5v VDD is connected to DLDO4.
Enable these regulators as well as the SATA support of Banana Pi M2 Ultra, by adding needed config lines into its defconfig. Signed-off-by: Icenowy Zheng <[email protected]> --- configs/Bananapi_M2_Ultra_defconfig | 3 +++ 1 file changed, 3 insertions(+) diff --git a/configs/Bananapi_M2_Ultra_defconfig b/configs/Bananapi_M2_Ultra_defconfig index c6da7274e1..4332eca68f 100644 --- a/configs/Bananapi_M2_Ultra_defconfig +++ b/configs/Bananapi_M2_Ultra_defconfig @@ -7,9 +7,12 @@ CONFIG_DRAM_ODT_EN=y CONFIG_MMC0_CD_PIN="PH13" CONFIG_MMC_SUNXI_SLOT_EXTRA=2 CONFIG_DEFAULT_DEVICE_TREE="sun8i-r40-bananapi-m2-ultra" +CONFIG_AHCI=y # CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set CONFIG_SPL=y CONFIG_SPL_I2C_SUPPORT=y # CONFIG_CMD_IMLS is not set # CONFIG_CMD_FLASH is not set # CONFIG_CMD_FPGA is not set +CONFIG_AXP_DLDO4_VOLT=2500 +CONFIG_AXP_ELDO3_VOLT=1200 -- 2.12.2 -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
