Hi everyone, This series, apart from some minor fixes, adds SPDIF output support with existing drivers.
The SPDIF transmitter block is the same as the one found on the H3. There is no receiver support. The A83T pinctrl and DMA engine drivers are already in the kernel. Patches 1 & 2 fix some overlooked errors in the A83T's new clk driver. Patch 3 fixes the name for the SPDIF pin function. We want to use well known standard names. (In addition, I found some of our drivers are using "s_twi" instead of "s_i2c". I will send fixes later.) Patch 4 adds a device node for the DMA controller. Patch 5 adds a device node and pinmux node for the SPDIF transmitter. Patch 6 enables SPDIF output on the Cubietruck Plus. Regards ChenYu Chen-Yu Tsai (6): clk: sunxi-ng: a83t: Fix PLL lock status register offset clk: sunxi-ng: a83t: Fix audio PLL divider offset pinctrl: sunxi: Fix SPDIF function name for A83T ARM: sun8i: a83t: Add device node for DMA controller ARM: sun8i: a83t: Add device node for SPDIF transmitter ARM: sun8i: a83t: cubietruck-plus: Enable SPDIF output arch/arm/boot/dts/sun8i-a83t-cubietruck-plus.dts | 22 +++++++++++++++++ arch/arm/boot/dts/sun8i-a83t.dtsi | 30 ++++++++++++++++++++++++ drivers/clk/sunxi-ng/ccu-sun8i-a83t.c | 4 ++-- drivers/pinctrl/sunxi/pinctrl-sun8i-a83t.c | 2 +- 4 files changed, 55 insertions(+), 3 deletions(-) -- 2.11.0 -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
