Add the required DT parts to enable Ethernet (dwmac-sun8i driver) on the Nano Pi NEO2 board. It uses an external Realtek RTL8211E PHY connected via RGMII to provide GbE network. Specially unlike other Allwinner boards, the phy is connected to MDIO address 7, not 1.
This includes the regulator (which is controlled by a GPIO pin) and the actual Ethernet MAC node, referring the RGMII pins of the device. Signed-off-by: Icenowy Zheng <[email protected]> --- .../boot/dts/allwinner/sun50i-h5-nanopi-neo2.dts | 27 ++++++++++++++++++++++ 1 file changed, 27 insertions(+) diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h5-nanopi-neo2.dts b/arch/arm64/boot/dts/allwinner/sun50i-h5-nanopi-neo2.dts index f2767b99c28a..968908761194 100644 --- a/arch/arm64/boot/dts/allwinner/sun50i-h5-nanopi-neo2.dts +++ b/arch/arm64/boot/dts/allwinner/sun50i-h5-nanopi-neo2.dts @@ -50,6 +50,7 @@ compatible = "friendlyarm,nanopi-neo2", "allwinner,sun50i-h5"; aliases { + ethernet0 = &emac; serial0 = &uart0; }; @@ -72,6 +73,16 @@ }; }; + reg_gmac_3v3: gmac-3v3 { + compatible = "regulator-fixed"; + regulator-name = "gmac-3v3"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + startup-delay-us = <100000>; + enable-active-high; + gpio = <&pio 3 6 GPIO_ACTIVE_HIGH>; + }; + reg_vcc3v3: vcc3v3 { compatible = "regulator-fixed"; regulator-name = "vcc3v3"; @@ -98,6 +109,22 @@ status = "okay"; }; +&emac { + pinctrl-names = "default"; + pinctrl-0 = <&emac_rgmii_pins>; + phy-supply = <®_gmac_3v3>; + phy-handle = <&ext_rgmii_phy>; + phy-mode = "rgmii"; + status = "okay"; +}; + +&mdio { + ext_rgmii_phy: ethernet-phy@7 { + compatible = "ethernet-phy-ieee802.3-c22"; + reg = <7>; + }; +}; + &mmc0 { pinctrl-names = "default"; pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin>; -- 2.12.2 -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
