Orange Pi One board has a SY8113B regulator, which is controlled via GPIO and capable of outputing 1.1V when the PL6 GPIO is set to output 0 or 1.3V when the PL6 GPIO is set to input or output 1, and the output is the power supply of the ARM cores in H3 SoC.
Add the device tree node of this regulator and set the cpu's cpu-supply property to it. Signed-off-by: Icenowy Zheng <[email protected]> --- New patch in v2. arch/arm/boot/dts/sun8i-h3-orangepi-one.dts | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+) diff --git a/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts b/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts index 82e5d28cd698..d8250aacfda1 100644 --- a/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts +++ b/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts @@ -88,6 +88,27 @@ gpios = <&r_pio 0 3 GPIO_ACTIVE_LOW>; }; }; + + reg_sy8113b: gpio-regulator { + compatible = "regulator-gpio"; + regulator-name = "vdd-cpux"; + regulator-type = "voltage"; + regulator-boot-on; + regulator-always-on; + regulator-min-microvolt = <1100000>; + regulator-max-microvolt = <1300000>; + regulator-ramp-delay = <50>; /* 4ms */ + + gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */ + enable-active-high; + gpios-states = <0x1>; + states = <1100000 0x0 + 1300000 0x1>; + }; +}; + +&cpu0 { + cpu-supply = <®_sy8113b>; }; &ehci0 { -- 2.15.1 -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
