On Tue, 5 Feb 2019 at 16:42, Chen-Yu Tsai <w...@csie.org> wrote:
>
> The MMC device tree bindings include properties used to signal various
> signalling speed modes. Until now the sunxi driver was accepting them
> without any further filtering, while the sunxi device trees were not
> actually using them.
>
> Since some of the H5 boards can not run at higher speed modes stably,
> we are resorting to declaring the higher speed modes per-board.
>
> Regardless, having boards declare modes and blindly following them,
> even without proper support in the driver, is generally a bad thing.
>
> Filter out all unsupported modes from the capabilities mask after
> the device tree properties have been parsed.
>
> Cc: <sta...@vger.kernel.org>
> Signed-off-by: Chen-Yu Tsai <w...@csie.org>
>
Applied for fixes, thanks!
Kind regards
Uffe
> ---
>
> This should be backported to stable kernels in case people try to run
> new device trees (that declare newly supported modes) with old kernels.
> ---
> drivers/mmc/host/sunxi-mmc.c | 15 +++++++++++++++
> 1 file changed, 15 insertions(+)
>
> diff --git a/drivers/mmc/host/sunxi-mmc.c b/drivers/mmc/host/sunxi-mmc.c
> index 7415af8c8ff6..70fadc976795 100644
> --- a/drivers/mmc/host/sunxi-mmc.c
> +++ b/drivers/mmc/host/sunxi-mmc.c
> @@ -1415,6 +1415,21 @@ static int sunxi_mmc_probe(struct platform_device
> *pdev)
> if (ret)
> goto error_free_dma;
>
> + /*
> + * If we don't support delay chains in the SoC, we can't use any
> + * of the higher speed modes. Mask them out in case the device
> + * tree specifies the properties for them, which gets added to
> + * the caps by mmc_of_parse() above.
> + */
> + if (!(host->cfg->clk_delays || host->use_new_timings)) {
> + mmc->caps &= ~(MMC_CAP_3_3V_DDR | MMC_CAP_1_8V_DDR |
> + MMC_CAP_1_2V_DDR | MMC_CAP_UHS);
> + mmc->caps2 &= ~MMC_CAP2_HS200;
> + }
> +
> + /* TODO: This driver doesn't support HS400 mode yet */
> + mmc->caps2 &= ~MMC_CAP2_HS400;
> +
> ret = sunxi_mmc_init_host(host);
> if (ret)
> goto error_free_dma;
> --
> 2.20.1
>
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to linux-sunxi+unsubscr...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
