On Wed, Mar 20, 2019 at 10:25 PM Srinivas Kandagatla <[email protected]> wrote: > On 18/03/2019 07:33, Chen-Yu Tsai wrote: > > From: Chen-Yu Tsai <[email protected]> > > > > Hi everyone, > > > > This series converts the sunxi_sid driver to read out data in native > > endianness for all Allwinner SoCs. It was already the case for the H3, > > which used a different read-out method. The endianness for this hardware > > was found to be either native or little endian [1], based on the data > > layout for the thermal sensor calibration data stored within. Some SoCs > > have either 1 or 3 sensors, and calibration data for each sensor is 2 > > bytes wide, with data for 2 sensors packed into 1 word. > > > > The first three patches do some clean-up and improvements of the code > > overall. The fourth patch converts the driver to reading out data in > > native endianness. The fifth adds support for the A83T and H5. These > > two were already listed in the device tree bindings. The last patch > > adds a device node for it on H3 and H5. > > > > Please have a look. > > > > Regards > > ChenYu > > > > [1] https://lkml.org/lkml/2019/2/18/134 > > > > Chen-Yu Tsai (6): > > nvmem: sunxi_sid: Read out SID for randomness without looping > > nvmem: sunxi_sid: Optimize register read-out method > > nvmem: sunxi_sid: Dynamically allocate nvmem_config structure > > nvmem: sunxi_sid: Read out data in native format > > nvmem: sunxi_sid: Support SID on A83T and H5 > > ARM: dts: sunxi: h3/h5: Add device node for SID > > > Applied all the nvmem patches except DTS patch to nvmem next
Thanks. Merged the DTS patch with Maxime's ack for 5.2. ChenYu -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
