The Boot ROM write some boot source ID (SD card, eMMC, SPI, ...) into
a certain location in SRAM, so the SPL can easily determine where to
load U-Boot proper from.
Factor out reading this value, as it will come in handy again shortly.
Signed-off-by: Andre Przywara <andre.przyw...@arm.com>
---
arch/arm/mach-sunxi/board.c | 18 +++++++++++++-----
1 file changed, 13 insertions(+), 5 deletions(-)
diff --git a/arch/arm/mach-sunxi/board.c b/arch/arm/mach-sunxi/board.c
index aa1d2230c9..9c0cf718b8 100644
--- a/arch/arm/mach-sunxi/board.c
+++ b/arch/arm/mach-sunxi/board.c
@@ -221,12 +221,22 @@ void s_init(void)
eth_init_board();
}
+#define SUNXI_INVALID_BOOT_SOURCE -1
+
+static int sunxi_get_boot_source(void)
+{
+ if (!is_boot0_magic(SPL_ADDR + 4)) /* eGON.BT0 */
+ return SUNXI_INVALID_BOOT_SOURCE;
+
+ return readb(SPL_ADDR + 0x28);
+}
+
/* The sunxi internal brom will try to loader external bootloader
* from mmc0, nand flash, mmc2.
*/
uint32_t sunxi_get_boot_device(void)
{
- int boot_source;
+ int boot_source = sunxi_get_boot_source();
/*
* When booting from the SD card or NAND memory, the "eGON.BT0"
@@ -244,11 +254,9 @@ uint32_t sunxi_get_boot_device(void)
* binary over USB. If it is found, it determines where SPL was
* read from.
*/
- if (!is_boot0_magic(SPL_ADDR + 4)) /* eGON.BT0 */
- return BOOT_DEVICE_BOARD;
-
- boot_source = readb(SPL_ADDR + 0x28);
switch (boot_source) {
+ case SUNXI_INVALID_BOOT_SOURCE:
+ return BOOT_DEVICE_BOARD;
case SUNXI_BOOTED_FROM_MMC0:
case SUNXI_BOOTED_FROM_MMC0_HIGH:
return BOOT_DEVICE_MMC1;
--
2.14.5
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to linux-sunxi+unsubscr...@googlegroups.com.
To view this discussion on the web, visit
https://groups.google.com/d/msgid/linux-sunxi/20200110014732.4185-2-andre.przywara%40arm.com.
