This enables passive cooling by down-regulating CPU voltage and frequency. For trip points, I used a slightly lowered values from the BSP code. The critical temperature of 110°C from BSP code seemed like a lot, so I rounded it off to 100°C.
The critical trip point value is 30°C above the maximum recommended ambient temperature (70°C) for the SoC from the datasheet, so there's some headroom even at such a high ambient temperature. Signed-off-by: Ondrej Jirman <[email protected]> --- arch/arm/boot/dts/sun8i-h3.dtsi | 25 +++++++++++++++++++++++++ 1 file changed, 25 insertions(+) v2: - added more detail to the commit description diff --git a/arch/arm/boot/dts/sun8i-h3.dtsi b/arch/arm/boot/dts/sun8i-h3.dtsi index 20217e2ca4d3a..e83aa6866e7ea 100644 --- a/arch/arm/boot/dts/sun8i-h3.dtsi +++ b/arch/arm/boot/dts/sun8i-h3.dtsi @@ -41,6 +41,7 @@ */ #include "sunxi-h3-h5.dtsi" +#include <dt-bindings/thermal/thermal.h> / { cpu0_opp_table: opp_table0 { @@ -227,6 +228,30 @@ cpu_thermal: cpu-thermal { polling-delay-passive = <0>; polling-delay = <0>; thermal-sensors = <&ths 0>; + + trips { + cpu_hot_trip: cpu-hot { + temperature = <80000>; + hysteresis = <2000>; + type = "passive"; + }; + + cpu_very_hot_trip: cpu-very-hot { + temperature = <100000>; + hysteresis = <0>; + type = "critical"; + }; + }; + + cooling-maps { + cpu-hot-limit { + trip = <&cpu_hot_trip>; + cooling-device = <&cpu0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>, + <&cpu1 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>, + <&cpu2 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>, + <&cpu3 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>; + }; + }; }; }; }; -- 2.25.1 -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/linux-sunxi/20200224165446.334712-1-megous%40megous.com.
