On Sun, Oct 25, 2020 at 02:01:44PM +0000, Adam Sampson wrote:
> The RX/TX delays for the Ethernet PHY on the Linksprite pcDuino 3 Nano
> are configured in hardware, using resistors that are populated to pull
> the RTL8211E's RXDLY/TXDLY pins low or high as needed.
>
> phy-mode should be set to rgmii-id to reflect this. Previously it was
> set to rgmii, which used to work but now results in the delays being
> disabled again as a result of the bugfix in commit bbc4d71d6354 ("net:
> phy: realtek: fix rtl8211e rx/tx delay config").
>
> Tested on two pcDuino 3 Nano boards purchased in 2015. Without this fix,
> Ethernet works unreliably on one board and doesn't work at all on the
> other.
>
> Fixes: 061035d456c9 ("ARM: dts: sun7i: Add dts file for pcDuino 3 Nano board")
> Signed-off-by: Adam Sampson <[email protected]>
Reviewed-by: Andrew Lunn <[email protected]>
Andrew
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web, visit
https://groups.google.com/d/msgid/linux-sunxi/20201025163429.GH792004%40lunn.ch.
