I recompile u-boot on h616 with emcp memory but in the sd card works perfect , but when I try install on internal emcp sys this error:
U-Boot SPL 2021.07 (Nov 16 2023 - 11:24:45 -0300) Error, wrong i2c adapter 1 max 1 possible DRAM: 1024 MiB Failed to set core voltage! set CPU 792000000hz frequency Trying to boot from MMC2 Card did not respond to voltage select! : -110 spl: mmc init failed with error: -95 SPL: failed to boot from all boot devices ### ERROR ### Please RESET the board ### whey boot with sd card says this message: U-Boot SPL 2021.07 (Nov 17 2023 - 10:14:40 -0300) Error, wrong i2c adapter 1 max 1 possible DRAM: 1024 MiB Failed to set core voltage! set CPU 792000000hz frequency Trying to boot from MMC1 NOTICE: BL31: v2.8(debug):v2.8 NOTICE: BL31: Built : 11:38:29, Oct 6 2023 NOTICE: BL31: Detected Allwinner H616 SoC (1823) NOTICE: BL31: Found U-Boot DTB at 0x4a088638, model: tanix tx6s INFO: ARM GICv2 driver initialized INFO: Configuring SPC Controller INFO: PMIC: Probing AXP305 on RSB WARNING: PMIC: No regulators DT node, skipping setup INFO: BL31: Platform setup done INFO: BL31: Initializing runtime services INFO: BL31: cortex_a53: CPU workaround for 855873 was applied INFO: BL31: cortex_a53: CPU workaround for 1530924 was applied INFO: PSCI: Suspend is unavailable INFO: BL31: Preparing for EL3 exit to normal world INFO: Entry point address = 0x4a000000 INFO: SPSR = 0x3c9 INFO: Changed devicetree. U-Boot 2021.07 (Nov 17 2023 - 10:14:40 -0300) Allwinner Technology CPU: Allwinner H616 (SUN50I) Model: tanix tx6s I2C: ready DRAM: 1 GiB MMC: mmc@4020000: 0, mmc@4022000: 2 Loading Environment from FAT... In: serial@5000000 Out: serial@5000000 Err: serial@5000000 Net: phy interface6 eth0: ethernet@5030000 starting USB... No working controllers found Hit any key to stop autoboot: 0 switch to partitions #0, OK mmc0 is current device Scanning mmc 0:1... Found U-Boot script /boot.scr 3247 bytes read in 1 ms (3.1 MiB/s) ## Executing script at 4fc00000 U-boot loaded from SD Boot script loaded from mmc 952 bytes read in 1 ms (929.7 KiB/s) -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to linux-sunxi+unsubscr...@googlegroups.com. To view this discussion on the web, visit https://groups.google.com/d/msgid/linux-sunxi/0ffff1a7-ff1e-4ccc-98df-c6ed06af045en%40googlegroups.com.
