Hello.
On 22-02-2011 8:55, Olof Johansson wrote:
To give one place to setup the pins that are used as GPIOs instead
of as their pinmuxed functions. Specifying enabled as false explicitly
disables the gpio mode of that pin (if left on by firmware).
This should remove the need for calling these from specific drivers and
thus reduce tegra-specific code from them.
Signed-off-by: Olof Johansson<[email protected]>
[...]
diff --git a/arch/arm/mach-tegra/include/mach/gpio.h
b/arch/arm/mach-tegra/include/mach/gpio.h
index e31f486..2369fba 100644
--- a/arch/arm/mach-tegra/include/mach/gpio.h
+++ b/arch/arm/mach-tegra/include/mach/gpio.h
@@ -20,6 +20,7 @@
#ifndef __MACH_TEGRA_GPIO_H
#define __MACH_TEGRA_GPIO_H
+#include<linux/init.h>
#include<mach/irqs.h>
#define TEGRA_NR_GPIOS INT_GPIO_NR
@@ -47,6 +48,12 @@ static inline int irq_to_gpio(unsigned int irq)
return -EINVAL;
}
+struct tegra_gpio_table {
+ int gpio; /* GPIO number */
+ bool enable; /* Enable for GPIO at init? */
+};
+
+void __init tegra_gpio_config(struct tegra_gpio_table *table, int num);
You don't need to annotate the declaration as __init.
WBR, Sergei
--
To unsubscribe from this list: send the line "unsubscribe linux-tegra" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
