On 01/06/2014 08:25 AM, Thierry Reding wrote:
> GPIO 1 and 2 of the PMIC are not used for the described purpose, so
> remove them.
As far as I can tell, this patch is correct, since those GPIOs are in
fact used to discharge the rails after disabling them, rather than to
enable/disable the rails.
Equally, these GPIOs affect multiple rails at once, so listing the GPIO
as a property of a single regulator seems wrong either way.
However, PMU_REGEN1 does seem to feed the "EN" pin of U13C1, a DC/DC
switcher for power rail 3.3v_modem, so perhaps there's more going on
here than I see?
In summary, I need Laxman to comment on this and ack the change, and
explain why these GPIOs were listed as regulator enables when it doesn't
seem that they are.
> Note: Removing these makes the work-in-progress eDP support work again.
> diff --git a/arch/arm/boot/dts/tegra124-venice2.dts
> b/arch/arm/boot/dts/tegra124-venice2.dts
> - vdd_3v3_reg: regulator@1 {
> - compatible = "regulator-fixed";
> - reg = <1>;
> - regulator-name = "vdd_3v3";
> - regulator-min-microvolt = <3300000>;
> - regulator-max-microvolt = <3300000>;
> - regulator-always-on;
> - regulator-boot-on;
> - enable-active-high;
> - gpio = <&as3722 1 GPIO_ACTIVE_HIGH>;
> - };
> -
> - vdd_3v3_modem_reg: regulator@2 {
> - compatible = "regulator-fixed";
> - reg = <2>;
> - regulator-name = "vdd-modem-3v3";
> - regulator-min-microvolt = <3300000>;
> - regulator-max-microvolt = <3300000>;
> - enable-active-high;
> - gpio = <&as3722 2 GPIO_ACTIVE_HIGH>;
> - };
Don't you want to simply remove the "enable-active-high" and "gpio"
properties, but leave the regulator definitions present, in case
something wants to reference these fixed(?) rails as their supply?
--
To unsubscribe from this list: send the line "unsubscribe linux-tegra" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
