On Fri, Jan 16, 2015 at 8:00 AM, Tomeu Vizoso <[email protected]> wrote:
> On 15 January 2015 at 19:35, Andrew Bresticker <[email protected]> wrote:
>> Hi Tomeu,
>>
>> On Thu, Jan 15, 2015 at 9:11 AM, Tomeu Vizoso <[email protected]> wrote:
>>> I have seen that coreboot configures these ones differently:
>>>
>>> - ('sdmmc3_clk_pa6', 'sdmmc3', None, 'none',
>>> False, False, False, False),
>>> + ('sdmmc3_clk_pa6', 'sdmmc3', None, 'none',
>>> False, True, False, False),
>>> - ('sdmmc3_clk_lb_out_pee4', 'sdmmc3', None, 'none',
>>> False, False, False, False),
>>> + ('sdmmc3_clk_lb_out_pee4', 'sdmmc3', None, 'down',
>>> False, True, False, False),
>>> - ('sdmmc4_cmd_pt7', 'sdmmc4', None, 'none',
>>> False, True, False, False),
>>> + ('sdmmc4_cmd_pt7', 'sdmmc4', None, 'up',
>>> False, True, False, False),
>>> - ('dp_hpd_pff0', 'dp', None, 'up',
>>> False, True, False, False),
>>> + ('dp_hpd_pff0', 'dp', None, 'none',
>>> False, True, False, False),
>>>
>>> May be good to have them match?
>>
>> I believe these should all be the same between Norrin (Nyan), Big, and
>> Blaze, so I'd go with whatever is in the Norrin pinmux config (which I
>> believe is what Simon's patch is based on).
>
> Even dp_hpd? In my testing I need to have pullup on big and with no
> pull on blaze for the panel to work. I'm very weak in reading
> schematics, but I see what I think is a pullup resistor in Big, and
> none in Blaze.
Maybe I'm missing something, but I don't see any difference between
Big and Blaze with respect to dp_hpd. Coreboot also configures them
both with no pull. I'll have to look into this more...
> So in summary, I think that we should make this change to the pinmux
> definition that Simon sent:
>
> - ('usb_vbus_en0_pn4', 'usb', None, 'none',
> False, True, True, False),
> - ('usb_vbus_en1_pn5', 'usb', None, 'none',
> False, True, True, False),
> + ('usb_vbus_en0_pn4', 'usb', None, 'up',
> False, True, False, False),
> + ('usb_vbus_en1_pn5', 'usb', None, 'up',
> False, True, False, False),
Yes. It ends up not mattering what the pull is when using a mainline
DTS since they use a fixed regulator to drive these pins high, but
you're right, the most correct thing for VBUS is input enabled with
pull-up.
--
To unsubscribe from this list: send the line "unsubscribe linux-tegra" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
