Brad Gass wrote:
> Apr 7 17:04:34 devel-uhci kernel: usb.c: USB device not accepting new address=2
>(error=-110)
> Apr 7 17:04:34 devel-uhci kernel: hub.c: USB new device connect on bus1/2, assigned
>device number 3
> Apr 7 17:04:37 devel-uhci kernel: usb_control/bulk_msg: timeout
> Apr 7 17:04:37 devel-uhci kernel: usb.c: USB device not accepting new address=3
>(error=-110)
Here are a few different workarounds I have found for this situation:
- Unload and reload the host controller driver without unplugging the camera, or...
- If you are using a hub, disconnect and reconnect either the upstream cable or the
power cable,
or...
- After loading the driver, plug the camera's USB connector in partway so that only
the power
contacts connect, and then plug it in all the way after waiting a half second or so.
This is difficult
to do, and only really a last resort.
--
Mark McClelland
[EMAIL PROTECTED]
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
http://lists.sourceforge.net/lists/listinfo/linux-usb-devel
