I have the above mentioned camera connected to a computer running kernel
2.2.19. When I connect the Ixus to USB (or when I turn it on) I get this
error messages:
usb-uhci.c: interrupt, status 2, frame# 1266
usb.c: USB device not accepting new address (error=-110)
usb.c: USB disconnect on device -1
After that, there is no sign of the camera in /dev/usb/* ...
More info about the system:
[root@lent usb]# lsmod
Module Size Used by
eepro100 16308 1
sb 33588 0 (unused)
uart401 5968 0 [sb]
parport_probe 3204 0 (unused)
parport 7060 0 [parport_probe]
usb-uhci 18652 0 (unused)
usbcore 42728 1 [usb-uhci]
sound 57208 0 [sb uart401]
soundcore 2372 6 [sb sound]
soundlow 300 0 [sound]
[root@lent usb]# cat /proc/interrupts
CPU0
0: 75256 XT-PIC timer
1: 3645 XT-PIC keyboard
2: 0 XT-PIC cascade
5: 1 XT-PIC soundblaster
8: 0 XT-PIC rtc
9: 2 XT-PIC usb-uhci
11: 3048 XT-PIC eth0
12: 6152 XT-PIC PS/2 Mouse
13: 1 XT-PIC fpu
14: 9012 XT-PIC ide0
NMI: 0
[root@lent usb]# lspci
00:00.0 Host bridge: Intel Corporation 430TX - 82439TX MTXC (rev 01)
00:07.0 ISA bridge: Intel Corporation 82371AB PIIX4 ISA (rev 01)
00:07.1 IDE interface: Intel Corporation 82371AB PIIX4 IDE (rev 01)
00:07.2 USB Controller: Intel Corporation 82371AB PIIX4 USB (rev 01)
00:07.3 Bridge: Intel Corporation 82371AB PIIX4 ACPI (rev 01)
00:08.0 VGA compatible controller: Matrox Graphics, Inc. MGA 1064SG [Mystique] (rev 03)
00:09.0 Ethernet controller: Intel Corporation 82557 [Ethernet Pro 100] (rev 04)
00:07.2 USB Controller: Intel Corporation 82371AB PIIX4 USB (rev 01)
(prog-if 00 [UHCI])
Flags: bus master, medium devsel, latency 64, IRQ 9
I/O ports at f800
What could be wrong? How can I get it to work?
Regards, Danilo
PS: I tried that with two different motherboards, one is an older Siemens
C5 (Pentium MMX based), the other is a new VIA based motherboard. The
results were identical.
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
http://lists.sourceforge.net/lists/listinfo/linux-usb-devel
